May 5, 2021Summer Sanitation Is Important as Ever
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
Oxyfluorfen,(Goal and Galigan) has become a popular and effective herbicide for use on cole crops even though it was first registered in the 1980’s. Oxyfluorfen is a contact herbicide with the same mode of action as Chateau, Aim, Shark, Gramoxone, Paraquat , Sharpen and ET. They are all PPO Inhibitors that rupture cell membranes. Carfentrazone (Aim, Shark), ET and Paraquat (Gramoxone), are effective only as postemergence applications to small weeds, Sharpen and Goal are effective both preemergence and early postemergence and Chateau is used only preemergence but can cause severe crop injury if mixed with a surfactant. The only one of these that is registered for cole crops is Oxyfluorfen (Goal, GoalTender, Galigan). It does not make sense for a contact herbicide to be used on weeds that have not emerged. The way this works is that a barrier is created with the herbicide on the surface that kills the seedling weeds as they come in contact with it. It is important not to disturb this barrier or the weeds will not be affected. Oxyfluorfen (Goal) is an herbicide that defies reason in other ways as well. It normally adheres strongly to the soil and has very low water solubility. It is well known, however, that Goal can lift off of the surface and cause crop injury. When this happens, it is evaporating or going from a liquid to a gas and this is unaffected by its solubility or adsorption. It also works well when chemigated through a sprinkler system. You would think that it would wash off, but it works well with less crop injury when chemigated. Chemigation is registered for onions only but it works well with cole crops as well. It only takes half as much (4 ounces) and is safer to the crop when chemigated. It is best to apply it about 2/3 of the way through the sprinkler run to keep it in place and flush the system.
Gearing up for the produce season, we already have been seeing plenty of fields transplanted with cole crops (cauliflower, cabbage, broccoli etc). Below are the few common diseases to watch out for.
This disease commonly affects seeds and young transplants and is caused by the soil-borne fungi such as Pythium, Fusarium, Rhizoctonia etc. Infected seeds decay in the soil. Seedlings and young transplants will “damp-off” or rot at the soil line, before they eventually collapse and die.
The fungus, Rhizoctonia solani, causes wirestem. Stems of plants become constricted and brittle at the soil line. The plant becomes stunted and may rot at the soil line. This disease is more severe on fall cole crops when the soil is warm. We have seen lot of this problem in the fields last year. Make sure you get certified disease free seedlings.
Prevention & Treatment: Cultural controls include planting on raised beds and providing good drainage. In greenhouse where transplants are grown, use new potting soil and new or thoroughly cleaned and disinfested containers and trays. Wash used containers with soapy water to remove all traces of old soil mix, and then briefly submerse containers in a 10% bleach solution. Allow to dry before planting in containers. Both in greenhouse and fields: avoid overwatering and wet feet in plants/seedlings.
Black rot is another common disease we observed in the fields last growing season. Black rot is caused by a bacterium, Xanthomonas campestris pathovar campestris, and can affect all vegetables in the crucifer family. Above-ground parts of the plant are primarily affected, and symptoms may vary depending on the type of plant, age of the plant and the environmental conditions. In general, yellow, V-shaped lesions appear along the tips of the leaves with the point of the V directed toward a vein. When lesions enlarge, wilted tissue expands toward the base of the leaves. Veins turn black or brown. Infection may spread into the stems. Cutting into the stems often reveals a black-brown discoloration with a yellowish slime present. Symptoms on cauliflower may appear as numerous black or brown specks, black veins and discolored curds.
Prevention & Treatment: With no effective curative measures available, preventative measures are very important. The bacteria survive the winter on plant debris and on weeds, such as wild mustard and Shepherd’s purse. It also can survive in and on seeds from infected plants. It can remain alive on plant residue buried in the soil for up to two years. The disease is easily spread by splashing water, wind, insects and garden tools. High temperatures and humidity favor development of the disease.
Use certified disease-free seed and transplants. If source of the seeds is unknown, or infested seedlots must be used, treat seed with hot water to eradicate pathogenic bacteria. Cabbage, broccoli, and Brussels sprouts can be treated at 122 °F for 25 minutes, while seeds of cauliflower, kale, turnip, and rutabaga are treated for 15 minutes. However, this treatment may reduce the viability of seed.
Choose varieties tolerant to black rot. Do not plant cole crops where black rot has occurred in the past two to three years. Select well-drained sites with good air circulation.
This disease is caused by the fungus Peronospora parasitica and can attack both seedlings and mature vegetable plants. Infected plants develop a gray mold on the lower leaf surface. The upper leaf surface of infected plants first turns yellow and then may turn brown or necrotic. Leaves wither and die. Symptoms differ from powdery mildew in that the downy mildew fungus grows only on the lower surface of the leaf. Development of the disease is favored by moist conditions.
Prevention & Treatment: Use varieties with resistant varieties. Rotate with crops other than cole crops or greens. Remove plant debris immediately after harvest. Use wide plant spacing to promote drying of leaves. For chemical control, make sure to rotate the fungicides to avoid development of resistance.
Alternaria Leaf Spot
Alternaria leaf sport is a common problem and sometimes may not be of economic importance. However, if the plants are already weak or physically damaged providing the site of infection, the disease can cause economic losses.
Mark C. Siemens
Vol. 12, Issue 9, Published 5/5/2021
Automated thinning machines have been commercially available since 2012. These machines identify crop plants and intermittently deliver an herbicidal spray or dose of liquid fertilizer to thin the stand to the desired plant spacing. Some growers have converted older machines to spot apply pesticides to crop plants rather than thin lettuce. Spot spraying just the crop plant makes sense – it reduces applied chemical amount by about 1/3rd as compared to band spraying and by roughly 90% as compared to broadcast. I have heard reports of improved efficacy with this technique, perhaps due to better coverage, however this potential benefit has not been validated in formal trials.
A drawback with automated thinning machines is their high cost. Retail prices for machines are approximately $25,000 per seed line, or about $200,000 for a 4-row, 2-line machine. Another option might be to use automated systems designed for spot spraying weeds. These devices have been commercially available since the mid 90’s and function similarly to automated thinning machines in that they use optical sensors to detect plants and solenoid activated spray assemblies to intermittingly spray unwanted plants (Fig. 1). The cost of these devices is quite reasonable – about $3,000 per unit, or about $24,000 for a 4-row, 2-line machine.
Automated spot sprayers are typically used in agriculture to control weeds in fallow fields (Fig. 2), but could easily be adapted to apply pesticides or even fertilizer to vegetable crops. Spot applying foliar fertilizers to vegetable crops is an interesting concept and is being investigated in California with lettuce.
Another potential use of spot sprayers is to control herbicide resistant weeds. The device can be positioned between crop rows to spot spray a non-selective herbicide to target weeds. Placing the sprayer in a hooded enclosure prevents unwanted drift onto crop plants. We are conducting trials using this technique in cotton this season (Fig. 3). We are also looking for collaborators interested in trying the device as a pesticide and/or fertilizer spot applicator in vegetable crops for this upcoming season. If you are interested collaborating or would like to see a demo of the device, please feel free to reach out to me.
The Yuma County Leaf Wetness Network remains in place for the 2018/19 vegetable season. Growers and PCAs may access information generated by the network by entering the following internet address: http://188.8.131.52:460
Upon entering the address above, you will be transferred to internet page that provides a series of tabs at the top of the page. Simply click on the tabs to access the information of interest.
Results of pheromone and sticky trap catches can be viewed HERE.
Results of pheromone and sticky trap catches can be viewed HERE.
Corn earworm: CEW moth activity increased a bit in the past 2 weeks but remains well below average for late spring.
Beet armyworm: Moth counts increased slightly, but remain very low consistent with seasonal temperatures, and below average for this point in the season.
Cabbage looper: Significant increase in activity in Dome Valley, Gila Valley and Tacna, but moth counts remain unusually low for this time of year, as they have all season.
Whitefly: No adult movement recorded across all locations and overall low numbers consistent with temperatures.
Thrips: Thrips adult movement beginning to pick up considerably, particularly in Yuma and Dome Valleys. Movement is below average for late March.
Aphids: Seasonal aphid counts down considerably compared with the Feb and Jan. Counts highest in Bard and Gila Valley. Below average movement for this time of year. Majority of species found on traps were green peach aphid.
Leafminers: Adult activity up slightly in some locations, but well below average for late season.