As is typical this time of the year, the weather has finally broken and it feels like “winter” has arrived in the desert. With cooler temperatures, you can expect a steady decline in insect abundance until temperatures begin to warm up again. Last fall, I felt that the insect pressure on produce and melons crops in the Yuma was as heavy as I’d seen in many years. This year it didn’t seem quite as heavy, but I’ve heard many PCAs complain of heavy insect pressure, particularly during November which was unusually warm. A quick look at both recent and historic data on pest abundance recorded from our research plots here in the Yuma area suggests that insect pressure this fall was a little lighter than last year, but still heavier as compared to previous years. First, whitefly adult numbers on fall melons and produce were extremely high in August, but monsoon rainfall in early September appeared to suppress their numbers for a couple of weeks thereafter. Much like last fall however, untreated melons plots on the Ag Center wilted and died rapidly as a direct result of heavy whitefly infestations. Sticky trap captures of whiteflies near cantaloupe fields from Wellton to Texas Hill, were lower than last fall, but were still higher than the previous four years. However, numbers of adults caught on traps in the Roll/Tacna area were higher in late-August this fall than we’ve ever recorded. Similarly, CYSDV incidence at harvest in cantaloupe fields in these areas was very high this fall. In all cases, high traps catches were found in melon fields in near proximity to cotton fields. Based on counts from untreated lettuce at the Yuma Ag Center, beet armyworm and cabbage looper population abundance this fall was slightly lower than last fall. However, worm pressure the past two years was higher than we’ve seen the previous 5 years. Populations began infesting plots in early September, and remained steady throughout October and into early November. Egg deposition and larval development has only recently declined significantly. Corn earworm numbers were lower than what we observed last year, but could still easily be found in untreated plots. Finally, Bagrada bug infestations were abundant in untreated broccoli plots at YAC for the 4th consecutive year. As expected, low-moderate population appeared in early September, but increased steadily through September and peaking in early October. Overall, the peak numbers observed were not as high as either 2010 or 2012, but much higher than in 2011. The infestation levels in our untreated broccoli plots this year remained at damaging levels throughout October and into mid-November. This is the first year we have seen Bagrada bugs this abundant in November. In contrast, similar to last fall, western flower thrips population numbers have been relatively low, but unlike last fall, we’ve been picking up winged green peach aphids and colonies on sticky traps and in untreated lettuce plots since early November. How these aphid and thrips numbers will translate into potential population pressure in January and February is unknown, but you should anticipate their abundance as usual. I’m often asked why we see such differences in insect pest numbers each year. It’s obviously a very complex question, and I don’t have a good answer. The bottom line; insect abundance and outbreaks are dictated by many abiotic, biotic and crop management factors within our cropping system. Moreover, it’s nearly impossible to consider all the factors necessary to draw a reliable conclusion. Nonetheless, graphics showing these recent trends in Whitefly, CYSDV, Lep Larvae and Bagrada abundance can be found at Pest Abundance on Desert Produce and Melon Cops in 2013.
2023-2024 Powdery Mildew of Lettuce Fungicide Trial
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 17, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
Max Temp (°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Powdery mildew (caused by Golovinomyces cichoracearum) efficacy trial treatments were made on February 15,2024, February 23, 2024, March 4, 2024, and March 12, 2024and .Disease was first seen on February 26,2024. Disease rating was done on March 15, 2024. Disease severity was determined by rating 10 plants within each of the four replicate plots per treatment using the following rating system: 0 = no powdery mildew present; 0.5 = one to a few very small powdery mildew colonies on bottom leaves; 1 = powdery mildew present on bottom leaves of plant; 2 = powdery mildew present on bottom leaves and lower wrapper leaves; 3 = powdery mildew present on bottom leaves and all wrapper leaves; 4 = powdery mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = powdery mildew present on entire plant. These ratings were transformed to percentage of leaves infected values before being statistically analyzed. Yield loss due to rejected lettuce heads would likely begin to occur on plants with a powdery mildew rating above 2.0 (percentage of leaves infected value of 40).
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most treatments significantly reduced the final severity of powdery mildew compared to nontreated plants. The most effective fungicides were Rhyme, Merivon, Quintec, Cevya, Luna Sensation, Luna Experience, and Elisys.
Band-Steam Applicator for Controlling Soilborne Pathogens and Weeds in Lettuce
Steam sterilization of soils is commonly used in plant nurseries and greenhouses for effective control of soilborne pathogens and weed seeds. The technique, however, is highly energy intensive as the entire soil profile is heated. This is too costly and slow to be practical for field scale vegetable production. To reduce energy consumption and cost, use of band-steaming, where steam is applied only in the area where it is needed – in the plant root zone, is proposed. In this method, narrow strips of soil centered on the seed line are treated with steam rather than the whole bed.
Over the course of the last year, we developed a prototype band-steam and co-product applicator that is designed to raise soil temperatures in a band 2” deep by 4” wide to levels sufficient to control soilborne pathogens (140 °F for > 20 minutes) and weed seed (150 °F for > 20 minutes). The device is principally comprised of a 35 BHP steam generator and a co-product applicator mounted on top of a bed shaper (Fig.1). The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper. An exothermic compound can be co-applied via shank injection and/or a banding spray nozzle. The rationale behind co-applying an exothermic compound with steam is that exothermic compounds react and release heat when combined with water, thereby reducing energy requirements and increasing travel speed.
Preliminary testing of the device this spring in Yuma, AZ were very promising. Trial results showed that application of steam alone effectively raised soil temperature in the center of the seed line to levels required for effective pest control (140 °F for more than 20 minutes). Use of the exothermic compound increased soil temperature by about 10 °F. A video of the device in action can be found at the link provided below.
We are currently evaluating the device in field trials with lettuce in Salinas, CA. Target pests in these experiments conducted in collaboration with Steve Fennimore, UC Davis, are soil pathogens which cause Sclerotinia lettuce drop and in-row weeds. Future articles will report the findings of this research.
This fall, we will be replicating these tests in Yuma, AZ and also investigating the effectiveness of band-steam for controlling Fusarium oxysporum f. sp. lactucae which causes Fusarium wilt of lettuce. Heat has been shown to effectively kill Fusarium oxysporum spores and control Fusarium wilt disease. As an example, soil solarization, where clear plastic is placed over crop beds during the summer, raises soil temperatures to 150-155˚F at the soil surface, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
These projects are sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
If you are interested in seeing the machine operate or would like more information, please feel free to contact me.
See the band-steam and co-product applicator in action!
References:
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
The volatility of herbicides, or the change from a solid or liquid to a gas, is dependent on several environmental factors and is extremely variable. We have been working on finding a replacement for Glyphosate for non-crop weed control and have tried to determine the stability of the potential herbicide alternatives. There are various methods used to measure herbicide volatility. All herbicides are initially tested in the laboratory to determine volatility and other properties. Volatility is specifically measured by placing a given volume of herbicide in a container, exposing it to various temperatures and humidity’s and then weighing how much is left. This is done under very controlled conditions. Another technique that is often the next step is to conduct bioassay studies in a greenhouse. This usually involves placing a container with the herbicide spray solution in a closed environment with sensitive plants. Injury to the bioassay plants are measured visually or by some other means. Field Studies are often conducted to measure herbicide volatility. This technique is the most applied, but the results are often imprecise and variable depending on environmental conditions. This commonly involves spraying an isolated area in the field and after the spray has settled placing sensitive plants at variable distances and directions away. Injury is observed or measured at variable time periods. We used this technique on June 10 to June 15 this year at the Yuma Valley Agriculture Center to measure volatility of 13 herbicides we are evaluating as alternatives to Glyphosate. Seven X 10 Ft. plots were sprayed, and tomato plants were placed 25Ft. away from each sprayed area on the north, south, east and west corners 1 hours after application A 50 Ft. buffer separated each sprayed plot. Visual injury was measured to the tomato plants at 24 and 48 hours after they were placed in the field. The 13 herbicides were used in this trial included 5 modes of action and are listed below.
The temperature reached above 100 F, the humidity was 10 to 20% and wind was 5 to 10 MPH during the trial. No injury symptoms were observed to any of the tomato plants from any of the herbicide treatments. The trial included low volatility formulations of the plant growth regulators, 2-4-D (Embed) and Dicamba (Enginia) which are often volatile under these hot and dry conditions. Neither of these two, or any of the other included herbicides, moved 25 ft or more in this one trial. We know, however, that in other trials the results have sometimes been different. Volatility is variable and difficult to measure in field trials.
Corn earworm:
CEW moth counts increased in most locations over the past 2 weeks; about average for this time of the season.
Beet armyworm:
Trap counts remain low in all locations, and below average for late-January.
Cabbage looper:
Cabbage looper trap counts increased in all locations, but still below average for mid-March.
Diamondback moth:
Adult activity decreased across all locations in the past two weeks. Overall, activity is below average for this time of year.
Whitefly:
Adult movement remained low in all locations consistent with previous seasons.
Thrips:
Thrips adult movement beginning to increase in all locations recently particularly in the Yuma Valley. Activity is well below average for mid-March.
Aphids:
Aphid movement low in most locations but increased slightly in Gila and Dome Valleys. Trap captures well below average for this time of the season.
Leafminers:
Adult activity increased in many areas, about average for this time of season.
