May 5, 2021Summer Sanitation Is Important as Ever
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
When known weedy fields are ready to plant and labor is expected to be short, it is tempting to use all the preplant herbicides that are available. In lettuce, there are three preplant herbicides available and it is not uncommon to use 2 and occasionally all 3 on the same crop. All three of these herbicides use the same mode of action to kill weeds. There are slight differences between them but they all either stop or disrupt cell division in the roots and or stems of the weeds. They are normally safe to lettuce unless the crop is stressed or the rate, timing or placement are poor. The rationale for using multiple preplant herbicides in lettuce is often to broaden the weed control spectrum or guard against misses caused by misapplication or environmental conditions. There are some hazards, however, that sometimes outweigh the benefits. Potential crop injury is increased. All 3 use the same mode of action and the chance of injuring developing crop roots is compounded. Sometimes herbicides are added that contribute nothing but potential injury to the mix. If you look at the following chart you can see that many weeds are controlled by Kerb, for instance, that are not controlled by Balan or Prefar. Why add them? All three control grasses, goosefoot and purslane. If environmental conditions and applications are optimal it is often possible to use only one. Herbicides are much less expensive than labor, but it is possible to overdo it and cause more problems and expense.
Downy mildew has always been one of the major problem for PCAs and growers in the desert southwest. The symptoms observed are green to yellow angular spots on the upper surface of the leaves and fluffy growth on the lower side (See Picture). Symptoms usually start from older leaves. As disease progresses the lesion turn brown and dry up and in some occasions, the disease can become systemic causing dark discoloration of vascular tissue.
Favorable condition for disease development:
The pathogen Bremia lactucae thrives in damp, cool condition, with moisture present on leaves. Spores are short-lived but dispersed efficiently by wind during moist period. Cultivated lettuce is the main host of the pathogen but it has also been reported to infectartichoke, cornflower and strawflower.
Why is downy mildew difficult to manage?
One of the main reason that hinders the disease management is the complexity of the pathogen. Bremia lactucae consists of multiple races (pathotypes), and new races continue to occur as pathogen evolves. The pathogen is one of the fastest evolving plant pathogen. And each pathotypes have developed insensitivity to fungicides to different extent.
One of the best practice is to grow resistant cultivar, but there are limitations. As the pathogen is highly variable and dynamic, resistant cultivars are not a permanent solution as the pathogen overcomes the resistance by evolving into virulent strains and isolates.
Preventative application of fungicides are effective to some extent. Reducing leaf wetness and humidity by using drip or furrow irrigation can be helpful. However, weather condition like rain during cool weather as we had in past couple of weeks is conducive to development of epidemics and we have very little control on that matter.
It Takes a Village:
And better yet the whole nation or world! Downy mildew is a bigger problem than we think. It is just not a problem in Arizona and California, it is a nationwide, worldwide problem. Thousands of plant pathologist/scientists/labs are working hard everyday to combat the disease.
Dr. Michelmore’s lab in University of California-Davis has been working on downy mildew for years and they need our help to build the database for next several years. Please let me (Bindu Poudel) or anyone in University of Arizona know if you see symptoms in the field. We can come collect the samples and send it to UC-Davis. The goal is to racetype as many isolates as possible to understand the genetic variability, the more information we have about the pathogen, the more it helps the scientific community come up with better management practice, better resistant cultivars etc.
Learn more about the Bremia Project:
Bremia Project Database:
Weed escapes are easy to spot in vegetable fields at harvest time. Some growers have these weeds pulled, bagged and removed by hand from the field because they are unsightly and to reduce seedbank loads. This can be a costly operation. An alternative solution might be to use high voltage electricity to kill these weeds. The idea of using electricity to “zap” weeds is not new. Machines for agriculture applications were developed decades ago and commercially available in the late 1970’s. Although the devices worked, they were not widely adopted due in part to the availability of low cost and efficacious herbicides.
Because of environmental concerns, herbicide resistant weed issues and increased organic production, non-chemical, high voltage weed control technology is seeing a resurgence. There are now five companies, three established within the last four years, offering or developing machines for commercial agriculture. Although configurations differ, all machines operate using the same principles. To explain, consider the example of the machine shown in Fig. 1. The unit comprises high voltage electrodes (8-15 kV) positioned above the crop canopy, an electric generator and a soil engaging coulter connected to ground. During operation, when an electrode touches a weed protruding above the canopy, current flows through the plant back to the generator via the ground contacting coulter. Current flow combined with electrical resistance in the plant causes rapid heating and plant fluids to vaporize. This ruptures cell walls and kills the plant. Although there are few recent reports in the literature, prior research on dated machines showed that the technique can provide better than 98% weed control in moderate weed densities (15,000 weeds/acre) at travel speeds of 2 mph (Diprose & Benson, 1984).
Modern approaches that utilize high voltage electricity in combination with smart machines to spot treat weeds are being developed. The idea is to use camera imagery and artificial intelligence to locate weeds and high voltage electricity to kill them. One such machine being developed by the MASCOR Institute1 and the Zasso Group is an autonomous robot equipped with cameras, on-board computers and robotic arms (Fig. 2). As the machine moves through the field, high voltage electrodes mounted on the movable, computer controlled robotic arms zap weeds. Another unit is being developed by Stekettee and RootWave. It is tractor pulled and designed to travel at 3 mph. Stekettee’s machine vision system identifies the weeds and RootWave’s high voltage electric technology shocks the weed with a pulsed 5 kV charge. Power is supplied by a generator connected to the tractor’s PTO. Both systems are in late stages of development with field tests conducted in 2020.
These systems appear promising and if they prove to be effective and economical, may be something to look for in the future.
1Reference to a product or company is for specific information only and does not endorse or recommend that product or company to the exclusion of others that may be suitable.
The Yuma County Leaf Wetness Network remains in place for the 2018/19 vegetable season. Growers and PCAs may access information generated by the network by entering the following internet address: http://22.214.171.124:460
Upon entering the address above, you will be transferred to internet page that provides a series of tabs at the top of the page. Simply click on the tabs to access the information of interest.
Beet armyworm: Moth activity has declined in most trap location and remains below average for this point in the season.
Cabbage looper: Cabbage looper activity remains unusually low for early November. Trap catches picked up a bit in Wellton and Gila Valley.
Whitefly: Adult movement has been about average for this time of year. Activity highest in Wellton near fall melons being harvested.
Thrips: Thrips activity picking up significantly in several trap locations; activity increased significantly in Bard and Dome and Gila Valleys.
Aphids: Aphid numbers peaked last week in many locations, particularly in the Gilas and Yuma Valleys.
Leafminers: Adult activity increased significantly last week, particularly in the Wellton area near melons.