We are beginning to observe winged (alate) aphids appearing on desert lettuce and cole crops, but proper identification of winged aphid species found on leafy vegetables in the desert is important for cost-effective pest management. Most of the important aphid species we find on local crops do not over-summer here because of high temperatures and lack of viable hosts. Thus, winged aphids typically begin migrating onto desert crops beginning in late October-early November, often being blown in with the gusting winds. My experience over the past 20 years suggests this is due in part to cooler weather more favorable for their behavior and development, as well as changes in prevailing winds that now begin to blow into the area from the north and west. Consequently, once the aphids reach our desert valleys, they typically move from crop to crop until they find a suitable host to feed and colonize on. It is not uncommon to find winged aphids on lettuce or broccoli that are specific pests of small grains (i.e., corn leaf aphid) or alfalfa (i.e., pea aphid). Because these aphid species will not colonize lettuce, it is important to be able to distinguish them from the key aphid pests commonly found on lettuce that do colonize and require management to prevent problems at harvest (green peach aphid, foxglove aphid, lettuce aphid). Also, you are likely to find cowpea aphid in lettuce as it can be common in alfalfa at this time. However, experience has shown us that although small cowpea aphid colonies may be found on lettuce, the populations rarely increase in lettuce crops. The bottom line: proper aphid identification can save a PCA time and money, and prevent unnecessary insecticide applications. A simple pictorial key provides provides information that can assist PCAs with identifying winged aphids. important in lettuce and other leafy vegetables.

As reductions of agricultural water allocations in central Arizona from the Colorado River are going into place in 2022 from the Tier 1 of the Drought Contingency Plan provisions, it is important for every segment of the Arizona agricultural industry to continue to review and refine our practices associated with water management and irrigation.  
 
Seasonal conditions are a benefit to vegetable crop production and water management in the desert Southwest, both in terms of cool-season crop adaptability and the general climatic conditions that create lower environmental crop water-use demands.  For example, based on more than 30 years of Arizona Meteorological Network (AZMET) data from the Yuma, Arizona area, approximately 20% of the total annual reference evapotranspiration demand typically occurs between August and May.  
 
Reference evapotranspiration (ETo) is the collective loss of water from a field due to evaporation from the soil surface and transpiration of water vapor from the plants.  Collectively, water movement from the soil and plant systems in a field is referred to as “crop consumptive use” and it is important to understand this process in our efforts to steward our water resources most effectively.
 
The AZMET system provides both historical and real-time weather information that can be used to assist in crop water and irrigation management.  Reference evapotranspiration values can be obtained daily from AZMET for the Yuma area and applicable to most of the region in the lower Colorado River Valley.  The ETo values multiplied by an appropriate crop coefficient (K_c) can provide very good estimates on actual crop evapotranspiration (ET_c) rates, ETo * K_c = ET_c.
 
The appropriate K_c values are specific for each crop species and stage of growth.  We commonly use crop coefficient K_cvalues that are provided in the publication “Consumptive Use by Major Crops in the Desert Southwest” by Dr. Leonard Erie and his colleagues, USDA-ARS Conservation Research Report No. 29 (see attached).  Reference information for K_cvalues can be obtained in this publication for common vegetable crops grown in this region.
 
Estimating and tracking actual crop-water use can be a valuable tool in understanding crop-water demand and irrigation management.  Comparing actual crop-water demand and crop irrigation practices can be important in our efforts to understand crop management needs and field-level efficiencies.
 
Reference:
Erie, L.J., O.A French, D.A. Bucks, and K. Harris. 1981. Consumptive Use of Water by Major Crops in the Southwestern United States.  United States Department of Agriculture, Conservation Research Report No. 29.

This study was conducted at the JV farms at Gila Valley. Lettuce variety ‘Guapo’ was seeded, then sprinkler-irrigated to germinate seed on September 19, 2023, on double rows 12 in. apart on beds with 42 in. between bed centers.  Rest of the irrigation was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned on October 9, 2023 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied by incorporating in soil before seeding or with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.

Month	Max	Min	Avg	Rain
September	100	71	86	0.71 in
October	93	61	77	0.00 in
November	80	51	65	0.08 in
December	71	44	57	0.82 in

 
Fusarium wilt (caused by Fusarium oxysporum f. sp. lactucae ) rating was done in the field by observing the typical symptom of lettuce wilt. Confirmation was done by cutting the cross section of roots. Disease scoring/rating was done on December 6, 2023. 
 
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. The disease pressure was extremely high in 2023, and most treatments showed little or no control against the disease. The treatments that showed some activity were Bexfond, Cevya, Rhyme, and Serifel. Plant vigor was normal and phytotoxicity symptoms were not observed in any treatments in this trial.

Automated thinning machines were first commercialized in 2012, almost a decade ago. Since then, the machines have improved tremendously, and automated thinning has become the standard practice in the Yuma area. As such, I was a bit surprised to see numerous fields this year with sub-optimal thinning performance. Many fields had numerous amounts of excess seedlings that should have been thinned and needed to be removed during the follow-up hand weeding/double removal operation (Fig. 1). There were also some fields where the machine was apparently not readily detecting seedlings, resulting in long sections of plants being killed and a poor final stand (Fig. 2).

Automated thinning machines can and do perform very well when set-up and calibrated correctly. However, field conditions such as lighting, levels of crop residue, weed pressure or soil type (color) change throughout the day and affect the way the machine chooses which plants to selectively thin.

As such, it may be beneficial to establish a protocol where automated thinning machine settings are checked at regular intervals throughout the day to ensure the unit is performing optimally. Doing so may help lower follow-up hand weeding/double removal costs and minimize the number of unnecessary skips in the field.

Fig. 1. Labor crew removing excess lettuce seedlings and weeds after machine thinning.


Fig. 2. Poor final stand establishment following machine thinning, possibly due to incorrect machine calibration.

Preemergence herbicides can be very effective in the low deserts where weeds germinate with every irrigation or rainfall. It is essential, however, that they be at the right place in the soil at the right time. The right place is in the soil around the weed seeds and the right time is when they are germinating. Only fumigants kill seeds. For most other herbicides, the seed must germinate and are then killed. When weed seeds germinate is dependent on a great number of interdependent variables.  These include weed species, soil type, moisture, soil temperature, condition of the seed, depth, organic matter and many other variables. Many seeds have biochemical mechanisms that allow them to germinate at different times. Some may germinate in a few hours and some may not germinate for several years. If they all germinated at the same time, they would be easier to control. The methods used to predict when weed seeds will germinate vary from very sophisticated numeric equations to Farmers Almanac type lore involving things like the thickness of gopher fur, the cuticle thickness of plants or the condition of bird feathers. Some methods will give you a precise day while others will give you just a general idea. In general, as the precision goes up, the accuracy goes down. Regardless of what technique you use, now is the best time to apply preemergence herbicides for the control of annual weeds. It is better to be a month early than a day late.We have conducted trials to determine how long it takes various weed species to germinate after receiving moisture. Results will vary depending on several factors and from field to field and year to year. Results are summarized below for individual species and by month. An average of all species is also included.
   Hours to Germination

NG = No germination

Results of recent pheromone and sticky trap catches can be viewed here.
 
Corn earworm:           
CEW moth counts decreased in the past 2 weeks and about average for this time of summer.
 
Beet armyworm:         
Trap counts stay active in some locations (Yuma Valley and Wellton) but about average for July.
 
Cabbage looper:          
Cabbage looper numbers remain low consistent with the lack of activity this fall compared to last season.
 
Diamondback moth:       
DBM moths were not caught in any trap in the past 2 weeks; average for this time of the year.
 
Whitefly:                       
Adult movement continuing to increase, particularly in Gila and Yuma Valleys consistent with melon harvest.
 
Thrips:                           
Thrips adults decreasing in most locations, and trending comparable to previous years.
 
Aphids:                        
Aphid movement is absent consistent with what we typically see in the summer. 
 
Leafminers:                  
Adult activity has highest in Yuma and Dome Valley, and above average for early July.