Now that spring has officially arrived, one question I've been contemplating is how did the cold weather this past winter impact pest pressure on our winter vegetables. There is no doubt that temperatures throughout Yuma County were considerably cooler this winter relative to last year, particularly during January and February. Based on my observations at the Yuma Ag Center, I would say that aphid and thrips numbers were lower than what we typically see during this period. It is quite reasonable to assume that the lower winter temperatures, coupled with lower rainfall amounts, likely kept aphid numbers relatively low. These cooler temperatures may also explain why, in some cases, Movento appeared to provide inconsistent activity against aphids. The systemic activity of the compound is influenced by the growth of the plant, and with the cooler temperatures and multiple freezes experienced this winter, both lettuce plant growth and aphid activity were likely negatively influenced. Thrips numbers are beginning to rapidly increase now, but during Jan and Feb, their numbers remained very low. Although we saw less rainfall this winter, the cooler temperatures clearly suppressed population growth. In addition, it appeared to be a little windier this winter, but average wind speeds varied within Yuma County. Wind can influence insect movement, several abiotic/biotic factors, and of course, the ability of PCAs to spray crops. Finally, the hard freezes we experienced this winter certainly impacted plant growth, quality and insect management. This was especially evident in the Gila Valley for instance where the AZMET weather station recorded 7 days when temperatures dropped below 32°F for an average of about 5 hours per freeze. This is significant when you consider that no freeze events were recorded all of last growing season. In contrast, Roll had 30 days of below 32°F temperatures, compared to 19 last year. Looking forward, what impact these freezes have had on key pests of spring melons (i.e., whiteflies, cabbage loopers) remains to be seen. For a detailed summary of the winter weather data described above, please go to Winter Weather Conditions Yuma. For a more detailed discussion on the impact of weather on insects refer to the article Weather and Insects.

As reductions of agricultural water allocations in central Arizona from the Colorado River are going into place in 2022 from the Tier 1 of the Drought Contingency Plan provisions, it is important for every segment of the Arizona agricultural industry to continue to review and refine our practices associated with water management and irrigation.  
 
Seasonal conditions are a benefit to vegetable crop production and water management in the desert Southwest, both in terms of cool-season crop adaptability and the general climatic conditions that create lower environmental crop water-use demands.  For example, based on more than 30 years of Arizona Meteorological Network (AZMET) data from the Yuma, Arizona area, approximately 20% of the total annual reference evapotranspiration demand typically occurs between August and May.  
 
Reference evapotranspiration (ETo) is the collective loss of water from a field due to evaporation from the soil surface and transpiration of water vapor from the plants.  Collectively, water movement from the soil and plant systems in a field is referred to as “crop consumptive use” and it is important to understand this process in our efforts to steward our water resources most effectively.
 
The AZMET system provides both historical and real-time weather information that can be used to assist in crop water and irrigation management.  Reference evapotranspiration values can be obtained daily from AZMET for the Yuma area and applicable to most of the region in the lower Colorado River Valley.  The ETo values multiplied by an appropriate crop coefficient (K_c) can provide very good estimates on actual crop evapotranspiration (ET_c) rates, ETo * K_c = ET_c.
 
The appropriate K_c values are specific for each crop species and stage of growth.  We commonly use crop coefficient K_cvalues that are provided in the publication “Consumptive Use by Major Crops in the Desert Southwest” by Dr. Leonard Erie and his colleagues, USDA-ARS Conservation Research Report No. 29 (see attached).  Reference information for K_cvalues can be obtained in this publication for common vegetable crops grown in this region.
 
Estimating and tracking actual crop-water use can be a valuable tool in understanding crop-water demand and irrigation management.  Comparing actual crop-water demand and crop irrigation practices can be important in our efforts to understand crop management needs and field-level efficiencies.
 
Reference:
Erie, L.J., O.A French, D.A. Bucks, and K. Harris. 1981. Consumptive Use of Water by Major Crops in the Southwestern United States.  United States Department of Agriculture, Conservation Research Report No. 29.

This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers.  All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 4, 2024  at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.

Month	MaxTemp(°F)	Min Temp (°F)	Average Temp (°F)	Rainfall
November	80	51	65	0.08 in
December	71	44	57	0.82 in
January	68	42	54	1.14 in
February	73	47	59	0.50 in

 
Downy mildew (caused by Bremia lactucae) rating was done on variety Eblin, Bobcat, and 180 (partially funded by AILRC grant). Disease was first seen on 1-30-24. Please see attached excel file for chemicals application date. Disease rating was done on February 29^, 2024. Disease severity was determined  by rating 10 plants within each of the five replicate plots per treatment using the following rating system: 0 = no downy mildew present; 0.5 = one to a few very small downy mildew colonies on bottom leaves; 1 = downy mildew present on bottom leaves of plant; 2 = downy mildew present on bottom leaves and lower wrapper leaves; 3 = downy mildew present on bottom leaves and all wrapper leaves; 4 = downy mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = downy mildew present on entire plant.
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most of the treatments exhibited activity against the disease to some extent. Latitude, Amara, Eject, Previcure flex exhibited good control in the variety Eblin (highly susceptible variety). Whereas Cevya, Stargus, Latitude, Amara, Revus, Thrive 4 M, Actigard, Instigo+Carbose+intereact showed activity against the pathogen in variety Bobcat. Please see excel file for the full list of chemicals and their efficacy. The lettuce variety 180 was resistant to the disease and no downy mildew was observed on the particular variety. No phytotoxicity was observed in this field.

Automated thinning machines were first commercialized in 2012, almost a decade ago. Since then, the machines have improved tremendously, and automated thinning has become the standard practice in the Yuma area. As such, I was a bit surprised to see numerous fields this year with sub-optimal thinning performance. Many fields had numerous amounts of excess seedlings that should have been thinned and needed to be removed during the follow-up hand weeding/double removal operation (Fig. 1). There were also some fields where the machine was apparently not readily detecting seedlings, resulting in long sections of plants being killed and a poor final stand (Fig. 2).

Automated thinning machines can and do perform very well when set-up and calibrated correctly. However, field conditions such as lighting, levels of crop residue, weed pressure or soil type (color) change throughout the day and affect the way the machine chooses which plants to selectively thin.

As such, it may be beneficial to establish a protocol where automated thinning machine settings are checked at regular intervals throughout the day to ensure the unit is performing optimally. Doing so may help lower follow-up hand weeding/double removal costs and minimize the number of unnecessary skips in the field.

Fig. 1. Labor crew removing excess lettuce seedlings and weeds after machine thinning.


Fig. 2. Poor final stand establishment following machine thinning, possibly due to incorrect machine calibration.

Preemergence herbicides can be very effective in the low deserts where weeds germinate with every irrigation or rainfall. It is essential, however, that they be at the right place in the soil at the right time. The right place is in the soil around the weed seeds and the right time is when they are germinating. Only fumigants kill seeds. For most other herbicides, the seed must germinate and are then killed. When weed seeds germinate is dependent on a great number of interdependent variables.  These include weed species, soil type, moisture, soil temperature, condition of the seed, depth, organic matter and many other variables. Many seeds have biochemical mechanisms that allow them to germinate at different times. Some may germinate in a few hours and some may not germinate for several years. If they all germinated at the same time, they would be easier to control. The methods used to predict when weed seeds will germinate vary from very sophisticated numeric equations to Farmers Almanac type lore involving things like the thickness of gopher fur, the cuticle thickness of plants or the condition of bird feathers. Some methods will give you a precise day while others will give you just a general idea. In general, as the precision goes up, the accuracy goes down. Regardless of what technique you use, now is the best time to apply preemergence herbicides for the control of annual weeds. It is better to be a month early than a day late.We have conducted trials to determine how long it takes various weed species to germinate after receiving moisture. Results will vary depending on several factors and from field to field and year to year. Results are summarized below for individual species and by month. An average of all species is also included.
   Hours to Germination

NG = No germination

 Areawide Insect Trapping Network   VegIPM Update, Vol. 15, No. 16, Aug 7, 2024
 
Results of pheromone and sticky trap catches can be viewed here.
 
Corn earworm:            
CEW moth counts decreased areawide; about average to previous years.
 
Beet armyworm:        
BAW moth counts decreased; comparable to previous summers.
 
Cabbage looper:         
Cabbage looper numbers are low consistent with previous years and higher temperatures.
 
Diamondback moth:     
DBM moths were not caught in any trap; average for this time of the year.
 
Whitefly:                     
Adult movement continues to decrease, average for this time of the year.
 
Thrips:                          
Thrips adult activity continues to decline, average for early August.
 
Aphids:                       
Aphid movement is absent and consistent with what we typically see during the summer.
 
Leafminers:                   
Adult activity declining and below average for early August.