Similar to this time last fall, the diamondback moth (DBM) is beginning to return to the desert, coincident with the establishment of early brassica transplants. We began to pick up a few DBM moths in traps near transplants and nurseries last week. Prior to this, the last DBM moth we captured in traps was in late June near a brassica seed crop. This is essentially how DBM began to build up last year. Quiet all summer, began very light in early September and then a gradual increase in trap counts in October. Of course, last year DBM was not a problem and PCA reported no issues in controlling populations on either transplanted and direct seeded crops. All the insecticide products we tested last year (including Coragen, Lannate and pyrethroids) provided good-excellent DBM control. I also had a couple of reports last week of low numbers of larvae showing up in transplanted fields in the Roll area. Again, similar to last fall. One thing we’ve learned based on pheromone trapping is that DBM moths are not captured during July and August; understandable since there are not sufficient brassica hosts for them to develop and reproduce. I am convinced that the local populations that show up each fall are immigrants coming into the area via monsoon and other tropical storms. The exception to this would be the outbreaks we experienced in 2016 where the DBM entered fields on infested transplants. That is known to occur in other areas of the country also (i.e., DBM from Florida transplants infesting cabbage in New York). What we don’t know in either case, is 1) what insecticide chemistries these transient DBM populations were exposed to prior to arrival, and 2) whether any of these populations may be resistant to a certain class(es) of chemistry. Thus, PCAs need to be careful to closely manage DBM populations that show up in early Sep/Oct. When larvae begin to show up, PCAs should act quickly to control these populations. They will likely get treated anyway as you treat for beet armyworm and cabbage looper. For more information of managing DBM on fall crops see Guidelines for Diamondback Moth Management in Fall Cole Crops. Note: If you sense any lack of DBM control with any of the products you use, please contact us immediately and we can collect populations to bioassay for susceptibility to Coragen, Radiant, Proclaim, Exirel. We currently have a colony started from larvae collected from Roll last week and will hopefully be testing it soon. We’ll let you know if we find anything unusual.
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 4, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
MaxTemp(°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Downy mildew (caused by Bremia lactucae) rating was done on variety Eblin, Bobcat, and 180 (partially funded by AILRC grant). Disease was first seen on 1-30-24. Please see attached excel file for chemicals application date. Disease rating was done on February 29, 2024. Disease severity was determined by rating 10 plants within each of the five replicate plots per treatment using the following rating system: 0 = no downy mildew present; 0.5 = one to a few very small downy mildew colonies on bottom leaves; 1 = downy mildew present on bottom leaves of plant; 2 = downy mildew present on bottom leaves and lower wrapper leaves; 3 = downy mildew present on bottom leaves and all wrapper leaves; 4 = downy mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = downy mildew present on entire plant.
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most of the treatments exhibited activity against the disease to some extent. Latitude, Amara, Eject, Previcure flex exhibited good control in the variety Eblin (highly susceptible variety). Whereas Cevya, Stargus, Latitude, Amara, Revus, Thrive 4 M, Actigard, Instigo+Carbose+intereact showed activity against the pathogen in variety Bobcat. Please see excel file for the full list of chemicals and their efficacy. The lettuce variety 180 was resistant to the disease and no downy mildew was observed on the particular variety. No phytotoxicity was observed in this field.
Controlling Disease and Weeds with Band-Steam – Yuma Trials Show Good Promise
In previous articles (Vol. 11 (13), Vol. 11 (20), Vol. 11(24)), I’ve discussed using band-steam to control plant diseases and weeds. Band-steaming is where steam is used to heat narrow strips of soil to temperature levels sufficient to kill soilborne pathogens and weed seed (>140 °F for > 20 minutes). The concept is showing good promise. This past season, three trials were conducted examining the efficacy of using steam for disease and weed control in Yuma, AZ. In the studies, steam was applied in a 4-inch-wide by 2-inch-deep band of soil centered on the seedline using a prototype band-steam applicator (Fig.1). The band-steam applicator is principally comprised of a 35 BHP steam generator mounted on top of an elongated bed shaper. The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper.
Trial results were very encouraging as the prototype applicator was able to raise soil temperatures to target levels (140°F for >20 minutes) at viable travels speeds of 0.75 mph. Steam provided better than 80% weed control and significantly lowered hand weeding time by more than 2 hours per acre (Table 1). Results also showed that Fusarium colony forming units (CFU) were reduced from 2,600 in the control to 155 in the 0.75 mph and 53 in the 0.5 mph treatments, respectively (a more than 15-fold reduction). A significant difference in Fusarium wilt of lettuce disease incidence was not found, however disease infection at the field site was low (< 2%) and differences were not expected. At 0.5 mph, fuel costs were calculated to be $238/acre which was considered reasonable and consistent with the values reported by Fennimore et al. (2014).
An unexpected finding was that plants in steam treated plots appeared to be healthier and more vigorous than untreated plots (Fig. 2). This trial is still in progress and it will be interesting to see if this improved early growth translates into increases in crop yield.
In summary, early trial results are showing good promise for use of band-steam as a non-herbicidal method of pest control. We plan on conducting further trials in this multi-year study. If you are interested in evaluating the device on your farm and being part of the study please contact me. We are particularly interested in fields with a known history of Fusarium wilt of lettuce and/or Sclerotinia lettuce drop that will be planted to iceberg or romaine lettuce.
As always, if you are interested in seeing the machine operate or would like more information, please feel free to contact me.
Acknowledgements
This work is supported by Crop Protection and Pest Management grant no. 2017-70006-27273/project accession no. 1014065 from the USDA National Institute of Food and Agriculture, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support. Any opinions, findings, conclusions, or recommendations expressed in this publication are those of the author(s) and do not necessarily reflect the view of the U.S. Department of Agriculture.
A special thank you is extended to Mellon Farms for allowing us to conduct this research on their farm.
References
Fennimore, S.A., Martin, F.N., Miller, T.C., Broome, J.C., Dorn, N. and Greene, I. 2014. Evaluation of a mobile steam applicator for soil disinfestation in California strawberry. HortScience 49(12):1542-1549.
Click link below or picture to see the band-steam and co-product applicator in action!
Carryover of Vegetable Herbicides to Wheat Grown in Rotation
Almost all the herbicides used on lettuce, cole crops and melons have restrictions on how soon wheat can be planted in rotation after they have been used. Experience has demonstrated, however, that safe intervals can vary considerably based upon many factors and are almost always much longer than they need to be. The most important factors are rate applied, irrigation practices and tillage. For example, when Kerb used to be banded at 2 to 4 lbs. per acre after planting and incorporated with furrow irrigation, it was common to see treated strips across wheat fields which followed. This is uncommon now that lower rates are Chemigated. We still see some Balan injury at ends of fields or in overlaps especially when sudan is planted. Wheat it not very sensitive to Prefar and carryover injury is uncommon.
Corn earworm:
CEW moth counts are down areawide and average for this time of year.
Beet armyworm:
Trap counts decreased in most locations; about average compared to previous years.
Cabbage looper:
Cabbage looper counts increased in most traps and about average for this time of season.
Diamondback moth:
DBM moths continue to increase in all areas. Below average for this time of the year.
Whitefly:
Adult movement negligible, typical for early January.
Thrips:
Currently, numbers are about average compared with previous years.
Aphids:
Aphid movement increased significantly in the past two weeks, particularly in North Yuma and Gila Valleys. Well above average for early January.
Leafminers:
Adults decreased in most locations, but above average for January.