To my surprise, the diamondback moth (DBM) has already returned to the desert, and its timely occurrence happens to coincide with the establishment of early brassica transplants. I was not anticipating this early of an arrival; but they are definitely here. We began to pick up a few DBM moths in traps during the week of Aug 19-26. The last moths caught prior to this was in early July near a brassica seed crop. Then during the week of Aug 26-Sep 2, traps captured a higher number of diamondback moth adults in several areas. A total of 22 DBM adults were caught in 7 traps during that week. May not sound like a lot, but more than what I expected. In all but one location, the moths were caught in traps located adjacent to newly transplanted cauliflower or cabbage fields (See DBM Trap Network). Moreover, since Monday we have seen a sharp increase in moths captured, particularly in Dome Valley and Wellton. At one trap location in Wellton, I counted 31 moths captured over 2 nights. There have also been a number of reports from PCAs in the past 2 days of adult DBM flying within fields. The interesting thing is that no one has reported any eggs, larvae or feeding damage on transplants in the fields where these adults are being found. Could be that the Verimark tray drenches are preventing DBM colonizarition so far. Time will tell. This early moth activity seems unusual to me, but maybe it’s because I’ve been looking so hard for them. The key question is where did these adults come from? The answer is important as it may indicate whether we are dealing with the same diamide resistant population we battled in 2016-17, or a completely different population with resistance to some other chemistry or nothing at all. In my view, there are 3 potential points of origin for these DBM adults. 1) Local Residents - I’ve always assumed DBM would not be capable of spending the summer (mid-June to mid-August) in the desert because of the lack of a suitable host. Our trapping data appears to support this hypothesis since we caught no moths during this period. But don’t know for sure. 2) Hitchhikers – another potential source could be the transplants themselves. Very possible, and can’t be ruled out, but the transplants where moths have been reported/captured have originated from six different nurseries so far (4 from coastal CA and 2 local). Have not picked up any DBM adults in direct seeded broccoli yet, but time may tell. 3) Immigrants - We know that DBM are capable of migrating long distances in winds, and given the widespread occurrences of the moths so far, it may be possible that recent storms may be bringing some of them into the area from the south. It may just be a coincidence that the large increase in moth activity in the last 2-3 days follows a tropical storm disturbance that moved through the area this pest weekend? We may never know the origin, but trust me we will continue to investigate. The bottom line: PCAs and growers should anticipate an early occurrence of DBM this season and prepare accordingly. For more information of managing DBM on fall crops see Guidelines for Diamondback Moth Management in Fall Cole Crops.
In response to the recent outbreaks of Diamondback moth (DBM) , Plutella xylostella in Yuma, we have established a pheromone trap network designed to monitor the activity and movement of adult populations of DBM. PCAs have had difficulty controlling DBM in cabbage, broccoli and cauliflower since October. Traps have been placed in Roll, Wellton, Dome Valley, Gila Valley and Yuma Valley in locations where cole crops are presently being grown or in areas where infestations were known to occur this fall.
Alfalfa is a major crop grown in Yuma area as a cover crop before vegetable season. Generally expected to be a hardy and easy crop to grow, alfalfa production still can be affected by many pests and diseases. Root and crown rot in alfalfa is a common problem. The pathogen Phytopthora megasperma thrives on standing water, overwatered, and/or in soil that lacks good drainage.
The above ground symptoms typically consists of plant wilting, usually occurring quite suddenly, often followed by plant death. The roots turn tan-to-brown, sometimes turning black. Sometimes orange-to-reddish streaks can be observed in rotted roots. Occasionally, the symptoms can be seen in crowns too. Infected plants succumb to death, or grow at reduced rate thus being susceptible to other pests and diseases.
The causal organism survives in soil as mycelia in infected plant tissue or as thick-walled oospores. It also produces thin-walled sporangia that release motile zoospores in the presence of free water. So it is important to grow alfalfa in well drained soils. Adjust irrigation water in a way that there is no standing water for too long. If possible, install tailwater ditch to remove excess water. Plant resistant cultivars like Agate, Apollo if the problem persists in the field. Till the soil deeply to reduce wet soil pockets, level the land before planting.
If diagnosis is confusing, bring the samples to the Yuma Plant Health Clinic for proper diagnosis. Make sure to bring healthy looking plants, sick plant, plants in between etc. Remember, there is no such thing as too much plant tissue when it comes to submitting samples to the clinic!
Controlling Disease and Weeds with Band-Steam – Yuma Trials Show Good Promise
In previous articles (Vol. 11 (13), Vol. 11 (20), Vol. 11(24)), I’ve discussed using band-steam to control plant diseases and weeds. Band-steaming is where steam is used to heat narrow strips of soil to temperature levels sufficient to kill soilborne pathogens and weed seed (>140 °F for > 20 minutes). The concept is showing good promise. This past season, three trials were conducted examining the efficacy of using steam for disease and weed control in Yuma, AZ. In the studies, steam was applied in a 4-inch-wide by 2-inch-deep band of soil centered on the seedline using a prototype band-steam applicator (Fig.1). The band-steam applicator is principally comprised of a 35 BHP steam generator mounted on top of an elongated bed shaper. The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper.
Trial results were very encouraging as the prototype applicator was able to raise soil temperatures to target levels (140°F for >20 minutes) at viable travels speeds of 0.75 mph. Steam provided better than 80% weed control and significantly lowered hand weeding time by more than 2 hours per acre (Table 1). Results also showed that Fusarium colony forming units (CFU) were reduced from 2,600 in the control to 155 in the 0.75 mph and 53 in the 0.5 mph treatments, respectively (a more than 15-fold reduction). A significant difference in Fusarium wilt of lettuce disease incidence was not found, however disease infection at the field site was low (< 2%) and differences were not expected. At 0.5 mph, fuel costs were calculated to be $238/acre which was considered reasonable and consistent with the values reported by Fennimore et al. (2014).
An unexpected finding was that plants in steam treated plots appeared to be healthier and more vigorous than untreated plots (Fig. 2). This trial is still in progress and it will be interesting to see if this improved early growth translates into increases in crop yield.
In summary, early trial results are showing good promise for use of band-steam as a non-herbicidal method of pest control. We plan on conducting further trials in this multi-year study. If you are interested in evaluating the device on your farm and being part of the study please contact me. We are particularly interested in fields with a known history of Fusarium wilt of lettuce and/or Sclerotinia lettuce drop that will be planted to iceberg or romaine lettuce.
As always, if you are interested in seeing the machine operate or would like more information, please feel free to contact me.
Acknowledgements
This work is supported by Crop Protection and Pest Management grant no. 2017-70006-27273/project accession no. 1014065 from the USDA National Institute of Food and Agriculture, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support. Any opinions, findings, conclusions, or recommendations expressed in this publication are those of the author(s) and do not necessarily reflect the view of the U.S. Department of Agriculture.
A special thank you is extended to Mellon Farms for allowing us to conduct this research on their farm.
References
Fennimore, S.A., Martin, F.N., Miller, T.C., Broome, J.C., Dorn, N. and Greene, I. 2014. Evaluation of a mobile steam applicator for soil disinfestation in California strawberry. HortScience 49(12):1542-1549.
Click link below or picture to see the band-steam and co-product applicator in action!
Carryover of Vegetable Herbicides to Wheat Grown in Rotation
Almost all the herbicides used on lettuce, cole crops and melons have restrictions on how soon wheat can be planted in rotation after they have been used. Experience has demonstrated, however, that safe intervals can vary considerably based upon many factors and are almost always much longer than they need to be. The most important factors are rate applied, irrigation practices and tillage. For example, when Kerb used to be banded at 2 to 4 lbs. per acre after planting and incorporated with furrow irrigation, it was common to see treated strips across wheat fields which followed. This is uncommon now that lower rates are Chemigated. We still see some Balan injury at ends of fields or in overlaps especially when sudan is planted. Wheat it not very sensitive to Prefar and carryover injury is uncommon.