Using Insecticides to Control Whiteflies in Spring Melons 2014
I discussed whitefly management briefly in our last update (April 30th, Vol. 5, No. 9), but thought it might be good to revisit the topic now that daytime temperatures are consistently in the 90’s and whitefly populations have reached levels that require treatment in many fields. Several factors play a role in determining which insecticide(s) you may want to apply. If the grower applied a neonicotinoid at planting (e.g., imidacloprid) the soil residual is long gone and it is likely no longer providing control of adults and newly emerging nymphs. Thus, if whitefly population abundance is sufficiently high enough to justify control, a foliar insecticide is recommended. When nymphs can easily be found on the crown and mid-vine leaves, an IGR or IGR-like product is recommended. This would include: Vetica, Courier, Oberon, and Knack. None of these products will provide good adult knockdown, but if applied correctly, will eventually suppress adult populations by preventing the development of the nymphs within the field. Experience has shown that these products can provide 14-21 days of residual control of nymphs. Control of adults infesting plants from outside sources will require a different approach. A Vydate+bifenthrin or Danitol tank-mixture is an option, but will likely only provide adult knockdown, with limited residual control (3-5 d). Among the neonicotinoids, Assail and Venom/Scorpion have shown the most consistent residual adult control (7-10 d) in experimental trials and will also provide decent control of nymphs on treated leaves. Because neonicotinoids are used on many crops grown throughout the year be sure to consider resistance management statements on the label as well as the UA Cross-commodity Guidelines before you apply them. This brings up another factor that is important to consider – presence of pollinators in or near the field. Be sure to check the label carefully for the Environmental Hazards statement, specifically for language and restrictions on honey bee safety. In some cases, products can be used effectively and safely through application timing and rates, whereas in other cases, some products should not be used when plants are flowering and pollinators are actively working fields. You must read the label carefully. The proximity to harvest may limit your choices as well. The PHIs for whitefly products vary anywhere from 0-7 days. Also, the presence of worms near harvest may influence your choice of products. If you’re using a whitefly specific product (e.g., Courier, Oberon, Knack, Assail) you might consider adding a pyrethroid for cabbage looper control, or a Lep material (e.g., Intrepid, Coragen, Belt, Vetica) for control of both looper and armyworm. Visit these publications for information on products available for Whitefly Control on Melons and Lepidopterous larvae management
2023-2024 Powdery Mildew of Lettuce Fungicide Trial
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 17, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
Max Temp (°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Powdery mildew (caused by Golovinomyces cichoracearum) efficacy trial treatments were made on February 15,2024, February 23, 2024, March 4, 2024, and March 12, 2024and .Disease was first seen on February 26,2024. Disease rating was done on March 15, 2024. Disease severity was determined by rating 10 plants within each of the four replicate plots per treatment using the following rating system: 0 = no powdery mildew present; 0.5 = one to a few very small powdery mildew colonies on bottom leaves; 1 = powdery mildew present on bottom leaves of plant; 2 = powdery mildew present on bottom leaves and lower wrapper leaves; 3 = powdery mildew present on bottom leaves and all wrapper leaves; 4 = powdery mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = powdery mildew present on entire plant. These ratings were transformed to percentage of leaves infected values before being statistically analyzed. Yield loss due to rejected lettuce heads would likely begin to occur on plants with a powdery mildew rating above 2.0 (percentage of leaves infected value of 40).
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most treatments significantly reduced the final severity of powdery mildew compared to nontreated plants. The most effective fungicides were Rhyme, Merivon, Quintec, Cevya, Luna Sensation, Luna Experience, and Elisys.
Controlling Disease and Weeds with Band-Steam – Yuma Trials Show Good Promise
In previous articles (Vol. 11 (13), Vol. 11 (20), Vol. 11(24)), I’ve discussed using band-steam to control plant diseases and weeds. Band-steaming is where steam is used to heat narrow strips of soil to temperature levels sufficient to kill soilborne pathogens and weed seed (>140 °F for > 20 minutes). The concept is showing good promise. This past season, three trials were conducted examining the efficacy of using steam for disease and weed control in Yuma, AZ. In the studies, steam was applied in a 4-inch-wide by 2-inch-deep band of soil centered on the seedline using a prototype band-steam applicator (Fig.1). The band-steam applicator is principally comprised of a 35 BHP steam generator mounted on top of an elongated bed shaper. The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper.
Trial results were very encouraging as the prototype applicator was able to raise soil temperatures to target levels (140°F for >20 minutes) at viable travels speeds of 0.75 mph. Steam provided better than 80% weed control and significantly lowered hand weeding time by more than 2 hours per acre (Table 1). Results also showed that Fusarium colony forming units (CFU) were reduced from 2,600 in the control to 155 in the 0.75 mph and 53 in the 0.5 mph treatments, respectively (a more than 15-fold reduction). A significant difference in Fusarium wilt of lettuce disease incidence was not found, however disease infection at the field site was low (< 2%) and differences were not expected. At 0.5 mph, fuel costs were calculated to be $238/acre which was considered reasonable and consistent with the values reported by Fennimore et al. (2014).
An unexpected finding was that plants in steam treated plots appeared to be healthier and more vigorous than untreated plots (Fig. 2). This trial is still in progress and it will be interesting to see if this improved early growth translates into increases in crop yield.
In summary, early trial results are showing good promise for use of band-steam as a non-herbicidal method of pest control. We plan on conducting further trials in this multi-year study. If you are interested in evaluating the device on your farm and being part of the study please contact me. We are particularly interested in fields with a known history of Fusarium wilt of lettuce and/or Sclerotinia lettuce drop that will be planted to iceberg or romaine lettuce.
As always, if you are interested in seeing the machine operate or would like more information, please feel free to contact me.
Acknowledgements
This work is supported by Crop Protection and Pest Management grant no. 2017-70006-27273/project accession no. 1014065 from the USDA National Institute of Food and Agriculture, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support. Any opinions, findings, conclusions, or recommendations expressed in this publication are those of the author(s) and do not necessarily reflect the view of the U.S. Department of Agriculture.
A special thank you is extended to Mellon Farms for allowing us to conduct this research on their farm.
References
Fennimore, S.A., Martin, F.N., Miller, T.C., Broome, J.C., Dorn, N. and Greene, I. 2014. Evaluation of a mobile steam applicator for soil disinfestation in California strawberry. HortScience 49(12):1542-1549.
Click link below or picture to see the band-steam and co-product applicator in action!
Carryover of Vegetable Herbicides to Wheat Grown in Rotation
Almost all the herbicides used on lettuce, cole crops and melons have restrictions on how soon wheat can be planted in rotation after they have been used. Experience has demonstrated, however, that safe intervals can vary considerably based upon many factors and are almost always much longer than they need to be. The most important factors are rate applied, irrigation practices and tillage. For example, when Kerb used to be banded at 2 to 4 lbs. per acre after planting and incorporated with furrow irrigation, it was common to see treated strips across wheat fields which followed. This is uncommon now that lower rates are Chemigated. We still see some Balan injury at ends of fields or in overlaps especially when sudan is planted. Wheat it not very sensitive to Prefar and carryover injury is uncommon.
Corn earworm:
CEW moth counts declined considerably over the past 2 weeks across all locations and about average for this time of the season.
Beet armyworm:
Trap counts decreased in most locations, but well below average for late-October. Most activity in Yuma and Gila Valleys.
Cabbage looper:
Cabbage looper trap counts declined in most areas but increased in the N. Yuma Valley. Activity below normal compared to previous years.
Whitefly:
Adults remains active in Dome Valley, Wellton, and Gila Valley, but below average movement for this time of season.
Thrips:
Thrips adult movement increased in most locations in the last 2 weeks, particularly in Dome, Wellton, and Tacna. Activity remains below average for late-October.
Aphids:
Aphid movement increased again sharply in Bard and Yuma and Gila Valleys consistent with N and E winds over the past 2 weeks. Capture about average for this time of year.
Leafminers:
Adult activity increased sharply in the Gila Valley and Wellton but remains below average for this time of season.
Diamondback moth:
Adults remains active in Dome Valley, Wellton, and Gila Valley, but below average movement for this time of season. Traps located adjacent to cauliflower and broccoli transplants had significantly higher counts, particularly in Dome Valley and Gila Valley.