Preparing for Fall Plantings: Insect / Weed Interactions
As fields are being prepared for fall plantings, PCAs and growers should be conscientious of weeds and how they may influence insect populations. Certainly, thorough weed management is important for the profitable production of vegetable crops in the desert southwest for all the obvious reasons. However, effective weed management is also essential for another important, but often overlooked, reason. Several common weed species found in and around vegetable crops can serve as host plants to many insect pests that can later infest nearby vegetable crops. Although flowering weeds can provide a reservoir for natural enemies (e.g., lady beetles, syrphid flies), and a source of nectar and pollen for pollinators, these same weedy refuges can serve as host sources for many key insect pests that cause economic damage to vegetable crops. Weeds found on field margins and ditch banks can provide insect pests with suitable resources needed for rapid population growth, which subsequently can lead to insect infestations occurring in adjacent vegetable crops. In addition, many weed species can provide insects with host plants that serve as a bridge between cropping seasons when vegetables crops are not in production (May-August). Volunteer melons emerging from previous spring plantings can also be considered weeds (“a plant out of place”). If not controlled in a timely manner, these volunteer weedy plants can sustain large numbers of insect pests (i.e., flea beetles and whiteflies), as well as plant viruses (e.g., CYSDV) that are transmitted by insect vectors, that can migrate onto newly planted fields. Finally, weeds left uncontrolled in vegetable crops can serve as impediments to insecticide applications. For example, dense weed foliage in vegetable and melon fields can negatively influence foliar spray applications by intercepting spray droplets before reaching the target crop, which can result in less insecticide deposition and unacceptable crop damage. Soil applied insecticides (e.g., Admire Pro, Verimark, Coragen) can also be impacted by unmanaged weed growth. Weeds growing unchecked during stand establishment can compete with the seedling plants for water and fertilizer, but they can also compete with crop plants for soil insecticides. Excessive weed densities can significantly intercept insecticides in the soil profile and reduce the amount available for uptake by the target crop. For more information on this topic, please visit this report: Interactions between Insects and Weeds in Desert Crops.
In response to the recent outbreaks of Diamondback moth (DBM) , Plutella xylostella in Yuma, we have established a pheromone trap network designed to monitor the activity and movement of adult populations of DBM. PCAs have had difficulty controlling DBM in cabbage, broccoli and cauliflower since October. Traps have been placed in Roll, Wellton, Dome Valley, Gila Valley and Yuma Valley in locations where cole crops are presently being grown or in areas where infestations were known to occur this fall.
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 4, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
MaxTemp(°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Downy mildew (caused by Bremia lactucae) rating was done on variety Eblin, Bobcat, and 180 (partially funded by AILRC grant). Disease was first seen on 1-30-24. Please see attached excel file for chemicals application date. Disease rating was done on February 29, 2024. Disease severity was determined by rating 10 plants within each of the five replicate plots per treatment using the following rating system: 0 = no downy mildew present; 0.5 = one to a few very small downy mildew colonies on bottom leaves; 1 = downy mildew present on bottom leaves of plant; 2 = downy mildew present on bottom leaves and lower wrapper leaves; 3 = downy mildew present on bottom leaves and all wrapper leaves; 4 = downy mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = downy mildew present on entire plant.
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most of the treatments exhibited activity against the disease to some extent. Latitude, Amara, Eject, Previcure flex exhibited good control in the variety Eblin (highly susceptible variety). Whereas Cevya, Stargus, Latitude, Amara, Revus, Thrive 4 M, Actigard, Instigo+Carbose+intereact showed activity against the pathogen in variety Bobcat. Please see excel file for the full list of chemicals and their efficacy. The lettuce variety 180 was resistant to the disease and no downy mildew was observed on the particular variety. No phytotoxicity was observed in this field.
Controlling Disease and Weeds with Band-Steam – Yuma Trials Show Good Promise
In previous articles (Vol. 11 (13), Vol. 11 (20), Vol. 11(24)), I’ve discussed using band-steam to control plant diseases and weeds. Band-steaming is where steam is used to heat narrow strips of soil to temperature levels sufficient to kill soilborne pathogens and weed seed (>140 °F for > 20 minutes). The concept is showing good promise. This past season, three trials were conducted examining the efficacy of using steam for disease and weed control in Yuma, AZ. In the studies, steam was applied in a 4-inch-wide by 2-inch-deep band of soil centered on the seedline using a prototype band-steam applicator (Fig.1). The band-steam applicator is principally comprised of a 35 BHP steam generator mounted on top of an elongated bed shaper. The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper.
Trial results were very encouraging as the prototype applicator was able to raise soil temperatures to target levels (140°F for >20 minutes) at viable travels speeds of 0.75 mph. Steam provided better than 80% weed control and significantly lowered hand weeding time by more than 2 hours per acre (Table 1). Results also showed that Fusarium colony forming units (CFU) were reduced from 2,600 in the control to 155 in the 0.75 mph and 53 in the 0.5 mph treatments, respectively (a more than 15-fold reduction). A significant difference in Fusarium wilt of lettuce disease incidence was not found, however disease infection at the field site was low (< 2%) and differences were not expected. At 0.5 mph, fuel costs were calculated to be $238/acre which was considered reasonable and consistent with the values reported by Fennimore et al. (2014).
An unexpected finding was that plants in steam treated plots appeared to be healthier and more vigorous than untreated plots (Fig. 2). This trial is still in progress and it will be interesting to see if this improved early growth translates into increases in crop yield.
In summary, early trial results are showing good promise for use of band-steam as a non-herbicidal method of pest control. We plan on conducting further trials in this multi-year study. If you are interested in evaluating the device on your farm and being part of the study please contact me. We are particularly interested in fields with a known history of Fusarium wilt of lettuce and/or Sclerotinia lettuce drop that will be planted to iceberg or romaine lettuce.
As always, if you are interested in seeing the machine operate or would like more information, please feel free to contact me.
Acknowledgements
This work is supported by Crop Protection and Pest Management grant no. 2017-70006-27273/project accession no. 1014065 from the USDA National Institute of Food and Agriculture, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support. Any opinions, findings, conclusions, or recommendations expressed in this publication are those of the author(s) and do not necessarily reflect the view of the U.S. Department of Agriculture.
A special thank you is extended to Mellon Farms for allowing us to conduct this research on their farm.
References
Fennimore, S.A., Martin, F.N., Miller, T.C., Broome, J.C., Dorn, N. and Greene, I. 2014. Evaluation of a mobile steam applicator for soil disinfestation in California strawberry. HortScience 49(12):1542-1549.
Click link below or picture to see the band-steam and co-product applicator in action!
Carryover of Vegetable Herbicides to Wheat Grown in Rotation
Almost all the herbicides used on lettuce, cole crops and melons have restrictions on how soon wheat can be planted in rotation after they have been used. Experience has demonstrated, however, that safe intervals can vary considerably based upon many factors and are almost always much longer than they need to be. The most important factors are rate applied, irrigation practices and tillage. For example, when Kerb used to be banded at 2 to 4 lbs. per acre after planting and incorporated with furrow irrigation, it was common to see treated strips across wheat fields which followed. This is uncommon now that lower rates are Chemigated. We still see some Balan injury at ends of fields or in overlaps especially when sudan is planted. Wheat it not very sensitive to Prefar and carryover injury is uncommon.
Corn earworm:First significant CEW moth activity since mid-November; particularly active in Dome/Wellton/Tacna areas.
Beet armyworm: Moth counts remain very low consistent with seasonal temperatures, but below average for this point in the season.
Cabbage looper: Slight increase in activity, but moth counts remain unusually low for this time of season.
Whitefly: Adult movement is at seasonal low consistent with temperatures and lack of melons or cotton.
Thrips: Thrips activity beginning to pick up, particularly in Tacna and Yuma Valley. Movement is still below average for February.
Aphids: Seasonal aphid counts peaked in early February and tending down last week. Counts remain high in Gila Valley and Wellton. Above average for this time of year.
Leafminers: Adult activity remains light in most trap locations. Trap counts increasing slightly in the South Gila Valley.
In response to the recent outbreaks of Diamondback moth (DBM) , Plutella xylostella in Yuma, we have established a pheromone trap network designed to monitor the activity and movement of adult populations of DBM. PCAs have had difficulty controlling DBM in cabbage, broccoli and cauliflower since October. Traps have been placed in Roll, Wellton, Dome Valley, Gila Valley and Yuma Valley in locations where cole crops are presently being grown or in areas where infestations were known to occur this fall.
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
