Flubendiamide The Arizona produce industry received some good news and some bad news recently. First, the bad news. Earlier this year, the U.S. Environmental Protection Agency (EPA) issued a notice with the intent to cancel flubendiamide products (Belt SC and Vetica) due to potential risks to aquatic invertebrates. Bayer Crop Science was asked to voluntarily cancel all flubendiamide registrations, but subsequently rejected the EPA’s decision and requested a hearing from Agency’s Administrative Law Judge and Environmental Appeals Board (EAB). Unfortunately, the Appeals Board has upheld the earlier EPA decision to cancel the registration of flubendiamide. So, as of today, Belt and Vetica can no longer be sold by Bayer or Nichino in the U.S., but the EAB decided that it would allow distributors and retailers to continue to distribute and sell existing stocks of the two products remaining in inventory. Thus PCAs and growers can continue using remaining product in inventory. This final decision is unfortunate since both Belt and Vetica are important cost-effective alternatives for worm control in produce and melon crops. In fact, among the diamide chemistries, Belt and Vetica were the most commonly used products in fall lettuce. For more information, see this Flubendiamide EAB Decision.
Sulfoxaflor The good news is that it appears that sulfoxaflor (Sequoia) will soon be registered and available for use on our leafy vegetable and brassica crops this winter. As you may recall the EPA was forced to cancel the sulfoxaflor registration in Nov 2015 based on a court ruling that the agency did not have enough scientific data to sufficiently demonstrate that sulfoxaflor had no unreasonable adverse effects to honey bees. Since then, EPA has been re-evaluating the sulfoxaflor label amended by Dow Agrosciences that now reduces or eliminates exposure to pollinators, and is proposing to unconditionally grant a Section 3 registration for certain crops including leafy vegetables and brassicas. Unfortunately, citrus, cotton and cucurbits are not included in the proposed registration. EPA concluded that sulfoxaflor will likely replace applications of pesticides that are at a higher risk to humans and other non-target organisms (including pollinators) and delaying its registration would delay these benefits. Before the cancellation of sulfoxaflor, Sequoia was used extensively for aphid management on winter and spring produce. For more information on the proposed label go to Proposed Registration of Sulfoxaflor.
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 4, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
MaxTemp(°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Downy mildew (caused by Bremia lactucae) rating was done on variety Eblin, Bobcat, and 180 (partially funded by AILRC grant). Disease was first seen on 1-30-24. Please see attached excel file for chemicals application date. Disease rating was done on February 29, 2024. Disease severity was determined by rating 10 plants within each of the five replicate plots per treatment using the following rating system: 0 = no downy mildew present; 0.5 = one to a few very small downy mildew colonies on bottom leaves; 1 = downy mildew present on bottom leaves of plant; 2 = downy mildew present on bottom leaves and lower wrapper leaves; 3 = downy mildew present on bottom leaves and all wrapper leaves; 4 = downy mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = downy mildew present on entire plant.
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most of the treatments exhibited activity against the disease to some extent. Latitude, Amara, Eject, Previcure flex exhibited good control in the variety Eblin (highly susceptible variety). Whereas Cevya, Stargus, Latitude, Amara, Revus, Thrive 4 M, Actigard, Instigo+Carbose+intereact showed activity against the pathogen in variety Bobcat. Please see excel file for the full list of chemicals and their efficacy. The lettuce variety 180 was resistant to the disease and no downy mildew was observed on the particular variety. No phytotoxicity was observed in this field.
Controlling Fusarium Wilt of Lettuce Using Steam Heat – Trial Initiated
Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).
Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.
If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.
References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.
Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed! It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials:
Corn earworm:
CEW moth captures have steadily decreased over the past 2 weeks, and areawide about average for late-October.
Beet armyworm:
Trap counts reached their highest levels so far this season, particularly in Tacna, Wellton and Yuma Valley, and about average for late October.
Cabbage looper:
Cabbage looper numbers decreased areawide, and are still below average for this time of the year.
Diamondback moth:
Sporadic DBM activity in low numbers throughout the area, trending well below average for late October.
Whitefly:
Adult movement increased in the past 2 weeks and above average for late October.
Thrips:
Thrips adult activity peaked in the last two weeks, and trending below average in October.
Aphids:
Winged adults continue to be captured for the season, consistent with heavy winds from W-NW. Aphid captures thus far have been well below average.
Leafminers:
Adult activity decreased in most areas, and trending about average for late October.