With the spring melon deal in Yuma finishing up in the next couple of weeks, now is the time to begin thinking about whitefly management in fall produce and melons crops. The first line of defense in avoiding whitefly issues in the fall produce/melon plantings is for PCAs and growers to do a good job of controlling whiteflies on cotton this summer. But before whitefly management begins in cotton, it is important that whitefly populations be prevented from building up to large numbers in the spring melons that have recently finished, or are nearing completion of harvest in the next few weeks. Although whitefly numbers have been relatively lighter this spring than normal, adult numbers have increased significantly over the past week in melons coinciding with higher temperatures and area-wide melon harvests. Growers and PCAs should not hesitate to knock these populations down on pre-harvest melons. Under current weather conditions (high temperatures) immature populations can rapidly build-up and cause honeydew/sooty mold contamination on fruit. Once harvest is complete, proper sanitation in spring melons is critical for preventing unnecessary whitefly migration into cotton and alfalfa. It is highly recommended that melon growers quickly destroy plant residue as soon as possible following harvest. A delay in disking under melon fields following harvest can provide a large source of adult whiteflies that will readily disperse into cotton and alfalfa, especially if they don't need to fly very far. These fields also potentially extend the host-acquisition period for CYSDV. Once melons fields have been disked and flat-watered, it is common for volunteer melons to germinate and emerge during July. The destruction of volunteer melons between spring and fall crops can reduce the source of whiteflies and virus inoculum available. This can be done by disking or applying a contact, burn-down herbicide to fields. Volunteer plants should be destroyed as soon as practical. Recent research has indicated that fall melons grown near spring melons with volunteers (<1.8 miles) are at a high risk of CYSDV infection. Ideally, it is in the Ag community’s best interest to use sound cultural management practices, such as sanitation, to eliminate and avoid unnecessary sources of whiteflies before the fall produce and melon seasons begin. For more information on cultural management practices for whiteflies see: Insect Management on Desert Melons: Whiteflies.
Alfalfa is a major crop grown in Yuma area as a cover crop before vegetable season. Generally expected to be a hardy and easy crop to grow, alfalfa production still can be affected by many pests and diseases. Root and crown rot in alfalfa is a common problem. The pathogen Phytopthora megasperma thrives on standing water, overwatered, and/or in soil that lacks good drainage.
The above ground symptoms typically consists of plant wilting, usually occurring quite suddenly, often followed by plant death. The roots turn tan-to-brown, sometimes turning black. Sometimes orange-to-reddish streaks can be observed in rotted roots. Occasionally, the symptoms can be seen in crowns too. Infected plants succumb to death, or grow at reduced rate thus being susceptible to other pests and diseases.
The causal organism survives in soil as mycelia in infected plant tissue or as thick-walled oospores. It also produces thin-walled sporangia that release motile zoospores in the presence of free water. So it is important to grow alfalfa in well drained soils. Adjust irrigation water in a way that there is no standing water for too long. If possible, install tailwater ditch to remove excess water. Plant resistant cultivars like Agate, Apollo if the problem persists in the field. Till the soil deeply to reduce wet soil pockets, level the land before planting.
If diagnosis is confusing, bring the samples to the Yuma Plant Health Clinic for proper diagnosis. Make sure to bring healthy looking plants, sick plant, plants in between etc. Remember, there is no such thing as too much plant tissue when it comes to submitting samples to the clinic!
Controlling Fusarium Wilt of Lettuce Using Steam Heat – Trial Initiated
Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).
Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.
If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.
References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.
Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed! It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials: