Over the past 2 weeks, whitefly adult numbers on fall melons have been extremely high in trials conducted at the Yuma Ag Center. In fact, based on numbers sampled from our untreated checks, adult numbers thus far have been almost 10-fold greater than what we've observed in the past several yea (see graph below). Furthermore, whitefly pressure has been exceptionally high in the Roll/Tacna area where our sampling has shown numbers in excess of 150 per leaf on pre-blooming plants in numerous fields. This high whitefly abundance can be attributed to some extent to the crop landscape in these areas. Crops planted near or adjacent to cotton and alfalfa are clearly more heavily infested. In addition, our monsoon conditions this year may be playing a role where total rainfall and average relative humidity during July and August have been higher this year than in the previous 10 years. Interestingly, these monsoon conditions were also very high in 2005 where, if you recall we had very heavy whitefly that year. Given that whitefly pressure does not appears to be letting up, PCAs should pay particular attention to early whitefly control on their newly planted produce crops. It is important that PCAs prevent prolonged feeding by high numbers of adults on seedling lettuce plants which can result in stunted growth. If you observe honeydew on leaves in the absence of nymphs then there are way too many adults on the seedling plants. Furthermore, allowing adults to remain on plants unchecked generally results in the development of large nymph populations which can cause significant growth/yield reductions in all produce crops. It is strongly recommended that growers apply a soil neonicotinoid on lettuce and cole crops throughout September and early October. Local research has shown that imidacloprid applied at 0.25 lbs AI/ac (e.g., Alias 2F-16 oz, Wrangler 4F-8 oz; Admire Pro- 7 oz) at planting provides less residual control of nymphs today than it did 10-12 years ago. Given the current economics of imidacloprid, cost-effective whitefly control can be achieved by using higher rates of imidacloprid to extend residual control ( e.g., Alias-24 oz, Wrangler- 12 oz or Admire Pro- 10.4 oz). Once plants get larger, products like Movento, Venom, Scorpion, Assail, Knack and Courier can provide effective control of nymphs. With the loss of endosulfan, growers have few options for effective adult control, but good knockdown can be achieved on lettuce and cole crops with combinations of bifenthrin (e.g. Brigade, Sniper, Discipline, etc) or Danitol tank-mixed with Orthene, Lannate, Lorsban, Venom, Scorpion, and Assail. For more information on whitefly biology, management and insecticide alternatives see Insect Management on Desert Vegetables and Melons: Whiteflies and Whitefly Management in Leafy Vegetables, Cole Crops and Melons
2023-2024 Powdery Mildew of Lettuce Fungicide Trial
This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Lettuce was seeded, then sprinkler-irrigated to germinate seed on Nov 28, 2023 on double rows 12 in. apart on beds with 42 in. between bed centers. All other water was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned Jan 17, 2024 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
Max Temp (°F)
Min Temp (°F)
Average Temp (°F)
Rainfall
November
80
51
65
0.08 in
December
71
44
57
0.82 in
January
68
42
54
1.14 in
February
73
47
59
0.50 in
Powdery mildew (caused by Golovinomyces cichoracearum) efficacy trial treatments were made on February 15,2024, February 23, 2024, March 4, 2024, and March 12, 2024and .Disease was first seen on February 26,2024. Disease rating was done on March 15, 2024. Disease severity was determined by rating 10 plants within each of the four replicate plots per treatment using the following rating system: 0 = no powdery mildew present; 0.5 = one to a few very small powdery mildew colonies on bottom leaves; 1 = powdery mildew present on bottom leaves of plant; 2 = powdery mildew present on bottom leaves and lower wrapper leaves; 3 = powdery mildew present on bottom leaves and all wrapper leaves; 4 = powdery mildew present on bottom leaves, wrapper leaves, and cap leaf; 5 = powdery mildew present on entire plant. These ratings were transformed to percentage of leaves infected values before being statistically analyzed. Yield loss due to rejected lettuce heads would likely begin to occur on plants with a powdery mildew rating above 2.0 (percentage of leaves infected value of 40).
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. Most treatments significantly reduced the final severity of powdery mildew compared to nontreated plants. The most effective fungicides were Rhyme, Merivon, Quintec, Cevya, Luna Sensation, Luna Experience, and Elisys.
Controlling Fusarium Wilt of Lettuce Using Steam Heat – Trial Initiated
Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).
Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.
If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.
References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.
Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed! It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials:
Corn earworm:
CEW moth captures have steadily decreased over the past 2 weeks, and areawide about average for late-October.
Beet armyworm:
Trap counts reached their highest levels so far this season, particularly in Tacna, Wellton and Yuma Valley, and about average for late October.
Cabbage looper:
Cabbage looper numbers decreased areawide, and are still below average for this time of the year.
Diamondback moth:
Sporadic DBM activity in low numbers throughout the area, trending well below average for late October.
Whitefly:
Adult movement increased in the past 2 weeks and above average for late October.
Thrips:
Thrips adult activity peaked in the last two weeks, and trending below average in October.
Aphids:
Winged adults continue to be captured for the season, consistent with heavy winds from W-NW. Aphid captures thus far have been well below average.
Leafminers:
Adult activity decreased in most areas, and trending about average for late October.