Summer is finally over. Brassica transplants are in the ground, and direct-seeded broccoli and lettuce plantings are now beginning. In the past week, I’ve observed or received reports from PCAs of key insect pests beginning to show up (or not) on melon and early produce crops in the desert.
Seedling pests: Flea beetles (FB) are beginning to show up in transplanted crops like they always do, but pressure has been light so far. We haven’t seen much in our experimental plots at YAC either. Remember, FB adults lay eggs in the soil of their favored local host plants (i.e., alfalfa, cotton, purslane, pigweed and nightshade) where larvae feed on the roots to later emerge as adults. So, keep in mind, the source of that FB infestations hitting your new stands may not just be freshly cut hay, defoliated cotton, or disked weeds. In some areas (Yuma Valley), crickets seem to be very abundant. Crickets like moisture and are often found under sprinkler pipes but can also be found in cracks in soils around fields or in drainage areas.
Bagrada bug: We’ve already had reports of bagrada bug adults on two transplanted cauliflower fields in Dome Valley. Not sure whether they arrived with the transplants or are moving from surrounding crops. However, it’s still early and they might surprise you as the season progresses. Look for those fresh feeding signs on cotyledons and young leaves. Experience suggests that they are most abundant after the humidity breaks.
Lepidopterous Larvae (worms): Worm pressure seems to be below normal. Trap catches so far show that Cabbage looper moths are almost non-existent, and no reports on melons to date. They should pick-up as we approach October. No reports of Beet armyworm larvae on the earliest transplants yet, and areawide pheromone traps suggest that moth activity is below normal. But they will show up sooner or later, so get ready. You have numerous insecticide alternatives at your disposal to control them. Have had a couple of reports of Diamondback moth larvae on newly transplanted brassica crops. However, we’ve yet to capture moths on pheromone traps which suggests that adult immigration on high altitude winds associated with storms has not occurred. Remember, DBM disappear each summer and reestablish on desert crops via transplants or migrate in on monsoon/tropical storms. I strongly stress that you check your Cole crops closely this fall, particularly following storms or on plants originating from coastal CA.
Whiteflies: Area wide sticky trap captures have been about normal for early September, but whiteflies can migrate long distances on high winds. Adult numbers increased on my melon plants last week and remain high. Reports in area melons range from light to moderate numbers so far, but there is still a lot of cotton out there yet to be picked. The good news is there are several insecticide alternatives to control them in produce.
Though sunflower is not a major crop in Arizona, it is one of the common ornamentals grown in home gardens. We have been witnessing some sunflowers in the area with the disease. It is also important to know about the diseases in sunflower as Arizona is home to large population of wild sunflowers.
Several species of the genus Rhizopus have been implicated in causing head rot, including R. arrhizus A. Fischer, R. stolonifer (Ehrenb.:Fr.) Vuill., and R. microsporus Tiegh. It has historically been considered to be of minor importance, however, it was documented as causing severe losses in Israel, and a recent survey of sunflower diseases in California found that Rhizopus head rot was the most common disease of sunflower. Under favorable conditions, it caused 100% losses in certain field. Infection is initiated in heads through wounds created by hail, birds, or insects.
Symptoms first become noticeable as dark spots on the back of ripening heads, followed by a watery soft rot that later turns brown. As disease progresses, heads dry prematurely, shrivel, and tissues appear to shred. Inside shredded tissues, coarse, thread-like mycelial strands are observed, followed by the appearance of small black dots (sporangia). Sporangia are filled with spores that are easily released and wind-blown to other plants. Symptoms on the flower side of heads include the appearance of mycelium, a grayish, fuzzy substance that is covered with sporangia (Fig 1-7)
Some type of mechanical injury on the head in combination with high temperatures and high relative humidity are required for infection and disease progress. Damage and economic losses are dependent upon time of the season that wounding and infection occurs. Infection rarely occurs before flowering, and greatest yield reductions result when infection occurs before seeds are properly filled. Infection in Israel has been primarily attributed to wounds from bird feeding. In the US High Plains, disease is initiated through head moth infestations and severe storms with hail.
Disease problems can be reduced by controlling the head moth at or before flowering, and by avoiding mechanical wounding after flowering. If you are growing sunflower commercially, it is also important to rogue or control volunteer and wild sunflowers before they produce seed; they may serve as a reservoir for insects and the Rhizopus.
Controlling Fusarium Wilt of Lettuce Using Steam Heat – Trial Initiated
Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).
Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.
If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.
References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.
Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed! It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials: