Now that the days are getting longer and the temperatures a bit warmer, aphids are likely to be more common. Experience has also shown us that aphid population growth begins to increase significantly once the weather warms in January. Our local weather forecast suggests that temperatures will be in the upper 60’s with moderate nighttime lows in the mid-40’s for the next two weeks. Assuming the weather service is correct, these conditions may be ideal for aphid population growth. Similarly, with the rainfall we experienced in December, I would keep an eye for aphid pressure to start picking up on your lettuce, celery, spinach and cole crops. Previous research has shown us that aphids tend to be more abundant during mild, wet winters.
So far, aphid appear to be ahead of schedule. Aphid flights peaked in mid-December which is a little later than what is expected (see graph below). There have been several reports of aphids showing up in both conventional and organic produce in the past 2 weeks, and at the Yuma Ag center, we have found enough green peach aphids colonizing small lettuce to initiate efficacy trials. Consequently, PCAs should be extra vigilant in scouting for aphid colonies. Be on the lookout for foxglove aphid too; they tend to be more biologically active under warmer temperatures (see Aphid ID Guide). If a field has been treated with imidacloprid at planting, then chances are you are in pretty good shape on young produce. However, imidacloprid doesn’t last all season. Regardless of whether you find green peach or foxglove aphid, the key to effective aphid management with foliar insecticides is to initiate sprays at the time apterous (wingless) aphids begin to colonize. The action threshold is the presence of aphid colonies on 5-10% of plants sampled. Of course, this requires diligent scouting and sampling. On older lettuce, make sure you thoroughly examine developing heads/hearts. Fortunately, PCAs have many alternatives for aphid control (see Aphid Management on Desert Produce_2020). So, keep your eyes open for new aphid colonies and treat early to keep ahead of the populations. For more information on aphid management see: Keys to Aphid Management in Leafy Vegetables.
As we wrap up lettuce season and move towards melon season, bacterial wilt of cucurbit is a disease we have to keep an eye on. Couple of years ago we had high incidence of this disease in fields.
Bacterial wilt is a common occurrence in commercial fields and residential gardens. This destructive disease can potentially result in complete crop loss even before the first harvest. Hosts Cucumber and muskmelon (cantaloupe) are highly susceptible; squash and pumpkin are less susceptible; watermelon is resistant.
Initially, individual leaves or groups of leaves turn dull green and wilt (Figure 1), followed by wilting of entire runners or whole plants. At first, plants may partially recover at night, but as disease progresses, wilt becomes permanent. Collapsed foliage and vines turn brown (necrotic), shrivel, and die (Figure 2). Wilt symptoms may be noticeable in as few as 4 days from infection on highly susceptible hosts but can take up to several weeks to become evident on crops that are less susceptible. Plant growth stage can also affect disease progress, which is more rapid on young, succulent plant tissues.
The diagnostic feature for this disease is the emission of a slimy, sticky ooze (exudate made of polysaccharides and bacterial cells) from cut stems. Field diagnosis can be confirmed using a simple “bacterial ooze test.” With a sharp knife, cut through a wilted (but not dead) vine; use a section near the crown (Figure 3A). Touch the cut ends together, and then slowly pull them apart. Fine thread-like strands of bacterial ooze will be drawn out (Figure 3B) when bacteria are present. This test works well for cucumber and muskmelon but is less reliable for squash or pumpkin. If this disease is present, a cloudy string or mass of bacterial ooze will flow into the water from the cut stem pieces (Figure 3C).
Bacterial wilt is caused by Erwinia tracheiphila; striped and spotted cucumber beetles (Fig 4 and 5) serve as vectors, carrying the bacterium from plant to plant during the growing season. The life cycles of the bacterial wilt organism and its vectors are closely associated, and bacterial wilt is directly correlated to striped and spotted cucumber beetle populations. These beetles hibernate through winter under leaf litter and in other protected sites; all the while, the bacterial wilt pathogen overwinters within the gut of the striped cucumber beetle. The beetles become active once temperatures remain above 55°F in spring. As soon as cucurbit seedlings begin to break through the ground, the beetles begin to feed on cotyledons and later feed on leaves, stems, and flowers. Striped cucumber beetle larvae also feed on root systems, causing damage that can result in wilt. The bacterial wilt organism is deposited through beetle mouthparts and the frass deposited onto/ into wounds created during beetle feeding. Once the bacterium invades a plant’s water conducting vessels (xylem), it spreads rapidly throughout the plant. The matrix of bacteria and ooze obstructs water movement in the xylem vessels, which causes wilt symptoms. Further spread of the pathogen occurs when beetles feed on diseased plants and then feed on nearby healthy plants. Close to harvest, a second generation of striped cucumber beetle may acquire the bacterium while feeding on infected plant tissues. Fall-planted cucurbits may be infected by this generation. These late-season adults will overwinter with the live bacterium in their gut and possibly transmit the pathogen to young plants the next spring. The bacterium cannot survive in infected plant debris from one season to the next.
Prevention of bacterial infections is dependent upon preventing cucumber beetle vectors from feeding on cucurbit plants. Early protection is critical for long-term disease management, which should begin as soon as seedlings emerge or when plants are transplanted into fields or gardens. Once it is evident that plants are infected, they should be removed from the site and destroyed. An early, aggressive management approach has been shown to reduce amounts of disease later in the season.
Start an insecticide program as soon as seedlings emerge or immediately after transplanting. This is critical to protecting very small plants from beetle feeding and, ultimately, from bacterial wilt. Bactericides are not recommended for management of bacterial wilt disease. Plastic and reflective mulches, crop rotation have shown promising effect against the insects.
Band-Steam Applicator for Controlling Soilborne Pathogens and Weeds in Lettuce
Steam sterilization of soils is commonly used in plant nurseries and greenhouses for effective control of soilborne pathogens and weed seeds. The technique, however, is highly energy intensive as the entire soil profile is heated. This is too costly and slow to be practical for field scale vegetable production. To reduce energy consumption and cost, use of band-steaming, where steam is applied only in the area where it is needed – in the plant root zone, is proposed. In this method, narrow strips of soil centered on the seed line are treated with steam rather than the whole bed.
Over the course of the last year, we developed a prototype band-steam and co-product applicator that is designed to raise soil temperatures in a band 2” deep by 4” wide to levels sufficient to control soilborne pathogens (140 °F for > 20 minutes) and weed seed (150 °F for > 20 minutes). The device is principally comprised of a 35 BHP steam generator and a co-product applicator mounted on top of a bed shaper (Fig.1). The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper. An exothermic compound can be co-applied via shank injection and/or a banding spray nozzle. The rationale behind co-applying an exothermic compound with steam is that exothermic compounds react and release heat when combined with water, thereby reducing energy requirements and increasing travel speed.
Preliminary testing of the device this spring in Yuma, AZ were very promising. Trial results showed that application of steam alone effectively raised soil temperature in the center of the seed line to levels required for effective pest control (140 °F for more than 20 minutes). Use of the exothermic compound increased soil temperature by about 10 °F. A video of the device in action can be found at the link provided below.
We are currently evaluating the device in field trials with lettuce in Salinas, CA. Target pests in these experiments conducted in collaboration with Steve Fennimore, UC Davis, are soil pathogens which cause Sclerotinia lettuce drop and in-row weeds. Future articles will report the findings of this research.
This fall, we will be replicating these tests in Yuma, AZ and also investigating the effectiveness of band-steam for controlling Fusarium oxysporum f. sp. lactucae which causes Fusarium wilt of lettuce. Heat has been shown to effectively kill Fusarium oxysporum spores and control Fusarium wilt disease. As an example, soil solarization, where clear plastic is placed over crop beds during the summer, raises soil temperatures to 150-155˚F at the soil surface, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
These projects are sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
If you are interested in seeing the machine operate or would like more information, please feel free to contact me.
See the band-steam and co-product applicator in action!
References:
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Sprangletop has become increasingly widespread in Arizona mostly because of its growth habits and tolerance to many commonly used herbicides. It is in the Leptochloa genus which is derived from the Greek words leptos (thin) and chloa (grass). There are more than 150 species of sprangletop worldwide but only three in Arizona and two in Yuma County. The two that are the most common in the low desert are Mexican Sprangletop, which is Leptochloa uninervia and Red Sprangletop, Leptochloa filiformis. A third species, Bearded Sprangletop, Leptochloa fascicularis, is more common at higher elevations of 1500 feet or higher. It is not uncommon to find both Red and Mexican Sprangletop in the same field and it is not hard to distinguish them when they are side by side. Red Sprangletop has a light green leaf blade which is similar in width to watergrass and barnyardgrass. It has very fine hairs and very small and fine branches and spiklets. It also has a long membranous ligule. The name Red refers to the leaf sheath, which is characteristically red, rather than the seed head. Mexican Sprangletop has a thinner leaf blade which is darker green or grayish in color and similar in appearance to common bermudagrass. The seed head is distinctly coarser than that of Red Sprangletop. Side by side, leaf color and size of the seed make it easy to distinguish these two. Both of these grasses are classified as summer annuals, but they grow more like perennials in the low desert. Sprangletop does very well in the hottest part of the summer and typically germinates from seed during the hottest period between July and September. Once established, however, it often survives through the cold winter months. It grows into clumps that often appear to be dead during the winter. New shoots commonly grow from these established crowns the next season. When this occurs, preemergent herbicides such as Trifluralin or Prowl are ineffective. Some Sprangletop plants stay green and grow through the winter. Many of the postemergence, grass specific herbicides that control many grasses are ineffective on Sprangletop. This also has contributed to the spread of these weeds. Sethoxydim (Poast) and Fluazifop (Fusilade) do not control either Red or Mexican sprangletop. Only Clethodim (Select Max, Select, Arrow and others) is the only one of these grass herbicides that is effective and only at the highest labeled rates. Two applications are often necessary to achieve season long control.
A new addition to the Veg IPM Updates this season is a pheromone/sticky trap monitoring network spanning the major growing areas in Yuma County. The project is designed to measure the activity and movement of adult populations of a number of key pests. The project is being funded by the Arizona Iceberg Lettuce Research Council, and will hopefully provide an indication of when pest activity (e.g., corn earworm moth flights) is increasing based on pheromone / sticky trap captures. The data is not intended to indicate field infestations, as trap data is largely a reflection of adult movement. If nothing else, the data may make PCAs aware of increased pest activity in some areas and encourage intensified scouting in susceptible produce fields. The pests being monitored include: corn earworm, tobacco budworm, beet armyworm, cabbage looper using pheromone traps; aphids, thrips and whiteflies using yellow sticky traps. A total of 8 trapping locations have been established in the following areas (approximate location):
Roll – 38E and Co. 5th St.
Wellton - 28E and Co. 10th St.
Dome – 18E and Co. 6th St.
S. Gila – Hwy 95 and Ave 10 E
N. Gila –Laguna Dam Rd and Co. 3rd St.
YAC – Somerton Ave and Co. 8th St.
YV mid – Ave C1/2 and Co. 15th St.
YV south – Ave H and Co. 19th St.
Traps will be checked weekly and data will be made available in the bi-weekly Veg IPM updates. If a PCA or grower is interested in weekly counts, those can be made available by contacting us. Below are the results of our first week of pheromone trapping which began on Sep 7th. Also included are whitefly and thrips counts from a few local areas initiated thus far.