As is typical this time of the year, the weather has finally broken and it feels like “winter” has arrived in the desert. With cooler temperatures, you can expect a steady decline in insect abundance until temperatures begin to warm up again. Last fall, I felt that the insect pressure on produce and melons crops in the Yuma was as heavy as I’d seen in many years. This year it didn’t seem quite as heavy, but I’ve heard many PCAs complain of heavy insect pressure, particularly during November which was unusually warm. A quick look at both recent and historic data on pest abundance recorded from our research plots here in the Yuma area suggests that insect pressure this fall was a little lighter than last year, but still heavier as compared to previous years. First, whitefly adult numbers on fall melons and produce were extremely high in August, but monsoon rainfall in early September appeared to suppress their numbers for a couple of weeks thereafter. Much like last fall however, untreated melons plots on the Ag Center wilted and died rapidly as a direct result of heavy whitefly infestations. Sticky trap captures of whiteflies near cantaloupe fields from Wellton to Texas Hill, were lower than last fall, but were still higher than the previous four years. However, numbers of adults caught on traps in the Roll/Tacna area were higher in late-August this fall than we’ve ever recorded. Similarly, CYSDV incidence at harvest in cantaloupe fields in these areas was very high this fall. In all cases, high traps catches were found in melon fields in near proximity to cotton fields. Based on counts from untreated lettuce at the Yuma Ag Center, beet armyworm and cabbage looper population abundance this fall was slightly lower than last fall. However, worm pressure the past two years was higher than we’ve seen the previous 5 years. Populations began infesting plots in early September, and remained steady throughout October and into early November. Egg deposition and larval development has only recently declined significantly. Corn earworm numbers were lower than what we observed last year, but could still easily be found in untreated plots. Finally, Bagrada bug infestations were abundant in untreated broccoli plots at YAC for the 4th consecutive year. As expected, low-moderate population appeared in early September, but increased steadily through September and peaking in early October. Overall, the peak numbers observed were not as high as either 2010 or 2012, but much higher than in 2011. The infestation levels in our untreated broccoli plots this year remained at damaging levels throughout October and into mid-November. This is the first year we have seen Bagrada bugs this abundant in November. In contrast, similar to last fall, western flower thrips population numbers have been relatively low, but unlike last fall, we’ve been picking up winged green peach aphids and colonies on sticky traps and in untreated lettuce plots since early November. How these aphid and thrips numbers will translate into potential population pressure in January and February is unknown, but you should anticipate their abundance as usual. I’m often asked why we see such differences in insect pest numbers each year. It’s obviously a very complex question, and I don’t have a good answer. The bottom line; insect abundance and outbreaks are dictated by many abiotic, biotic and crop management factors within our cropping system. Moreover, it’s nearly impossible to consider all the factors necessary to draw a reliable conclusion. Nonetheless, graphics showing these recent trends in Whitefly, CYSDV, Lep Larvae and Bagrada abundance can be found at Pest Abundance on Desert Produce and Melon Cops in 2013.
Bacterial Fruit Blotch (BFB) in melon seedlings (2024)
Bacterial fruit blotch (BFB) of melon is caused by the bacterium Acidovorax avenae subsp. Citrulli. The bacteria produces large olive green to brown water-soaked lesions on fruit, making them unmarketable. Symptoms of BFB on seedlings begin with water-soaked areas on the lower surface of the cotyledons and inconspicuous lesions on leaves. BFB lesions will become necrotic often with yellow halos. Lesions are frequently delimited by veins. Infected seedlings collapse and die. Greenhouse conditions are usually favorable for dispersal and establishment of pathogen. Thus, good greenhouse practices and sanitation is extremely important. Clean transplant trays must be used (disinfect trays if they will be reused) and new soil. Destroy any volunteer seedlings and keep the area in and around the greenhouse weed free. Avoid overhead watering if at all possible, or water in the middle of the day so that the plants dry thoroughly before evening. The bacterium can spread on mist and aerosols. Relative humidity should be kept low through proper watering and good air circulation in the greenhouse. Separate different seedlots, to reduce lot-to-lot spread. Monitor these isolated seedlings daily and destroy trays where symptoms develop. The remaining trays should be sprayed with a labeled bactericide and the applications continued until the plants are transplanted to the field. The pathogen can be seedborne, so growers should only use seed that has been tested for the presence of the pathogen by a reputable testing facility. Management of BFB includes a combination of preventing the introduction of the pathogen, sanitation to eliminate any inoculum present, and the use of bactericides if the disease appears. There are no commercially available watermelon cultivars that are resistant to bacterial fruit blotch, but there is some variation in susceptibility among cultivars.
Band-Steam Applicator for Controlling Soilborne Pathogens and Weeds in Lettuce
Steam sterilization of soils is commonly used in plant nurseries and greenhouses for effective control of soilborne pathogens and weed seeds. The technique, however, is highly energy intensive as the entire soil profile is heated. This is too costly and slow to be practical for field scale vegetable production. To reduce energy consumption and cost, use of band-steaming, where steam is applied only in the area where it is needed – in the plant root zone, is proposed. In this method, narrow strips of soil centered on the seed line are treated with steam rather than the whole bed.
Over the course of the last year, we developed a prototype band-steam and co-product applicator that is designed to raise soil temperatures in a band 2” deep by 4” wide to levels sufficient to control soilborne pathogens (140 °F for > 20 minutes) and weed seed (150 °F for > 20 minutes). The device is principally comprised of a 35 BHP steam generator and a co-product applicator mounted on top of a bed shaper (Fig.1). The apparatus applies steam via shank injection and from cone shaped ports on top of the bed shaper. An exothermic compound can be co-applied via shank injection and/or a banding spray nozzle. The rationale behind co-applying an exothermic compound with steam is that exothermic compounds react and release heat when combined with water, thereby reducing energy requirements and increasing travel speed.
Preliminary testing of the device this spring in Yuma, AZ were very promising. Trial results showed that application of steam alone effectively raised soil temperature in the center of the seed line to levels required for effective pest control (140 °F for more than 20 minutes). Use of the exothermic compound increased soil temperature by about 10 °F. A video of the device in action can be found at the link provided below.
We are currently evaluating the device in field trials with lettuce in Salinas, CA. Target pests in these experiments conducted in collaboration with Steve Fennimore, UC Davis, are soil pathogens which cause Sclerotinia lettuce drop and in-row weeds. Future articles will report the findings of this research.
This fall, we will be replicating these tests in Yuma, AZ and also investigating the effectiveness of band-steam for controlling Fusarium oxysporum f. sp. lactucae which causes Fusarium wilt of lettuce. Heat has been shown to effectively kill Fusarium oxysporum spores and control Fusarium wilt disease. As an example, soil solarization, where clear plastic is placed over crop beds during the summer, raises soil temperatures to 150-155˚F at the soil surface, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
These projects are sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
If you are interested in seeing the machine operate or would like more information, please feel free to contact me.
See the band-steam and co-product applicator in action!
References:
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Sprangletop has become increasingly widespread in Arizona mostly because of its growth habits and tolerance to many commonly used herbicides. It is in the Leptochloa genus which is derived from the Greek words leptos (thin) and chloa (grass). There are more than 150 species of sprangletop worldwide but only three in Arizona and two in Yuma County. The two that are the most common in the low desert are Mexican Sprangletop, which is Leptochloa uninervia and Red Sprangletop, Leptochloa filiformis. A third species, Bearded Sprangletop, Leptochloa fascicularis, is more common at higher elevations of 1500 feet or higher. It is not uncommon to find both Red and Mexican Sprangletop in the same field and it is not hard to distinguish them when they are side by side. Red Sprangletop has a light green leaf blade which is similar in width to watergrass and barnyardgrass. It has very fine hairs and very small and fine branches and spiklets. It also has a long membranous ligule. The name Red refers to the leaf sheath, which is characteristically red, rather than the seed head. Mexican Sprangletop has a thinner leaf blade which is darker green or grayish in color and similar in appearance to common bermudagrass. The seed head is distinctly coarser than that of Red Sprangletop. Side by side, leaf color and size of the seed make it easy to distinguish these two. Both of these grasses are classified as summer annuals, but they grow more like perennials in the low desert. Sprangletop does very well in the hottest part of the summer and typically germinates from seed during the hottest period between July and September. Once established, however, it often survives through the cold winter months. It grows into clumps that often appear to be dead during the winter. New shoots commonly grow from these established crowns the next season. When this occurs, preemergent herbicides such as Trifluralin or Prowl are ineffective. Some Sprangletop plants stay green and grow through the winter. Many of the postemergence, grass specific herbicides that control many grasses are ineffective on Sprangletop. This also has contributed to the spread of these weeds. Sethoxydim (Poast) and Fluazifop (Fusilade) do not control either Red or Mexican sprangletop. Only Clethodim (Select Max, Select, Arrow and others) is the only one of these grass herbicides that is effective and only at the highest labeled rates. Two applications are often necessary to achieve season long control.