With the produce season winding down and the melon season getting started, now is a good time to review the insecticide chemistries that are commonly used on desert crops to control insect pests. This is important. To sustain the insecticide efficacy that annually provides PCAs and growers with cost-effective crop protection requires a conscious effort to prevent insecticide resistance. Over the past 20 years, the Agrochemical Industry has developed and brought to the market an unprecedented number of new chemistries that are highly effective, selective and more safe than their chemical predecessors. These include the neonicotinoids, spinosyns, tetramic acid derivatives and diamides to name a few. However, the development of new chemistries has slowed a bit, and older chemistries are continually being phased out of the marketplace (don't forget, we lost endosulfan last summer). Thus, it is imperative to sustain the efficacy of these newer IPM tools currently available, and makes insecticide resistance management (IRM) more important than ever. The most fundamental approach to IRM is to minimize the selection of resistance to any one type of insecticide. Historically, alternating or rotating compounds with different modes of action has provided sustainable and effective IRM in our desert cropping systems. The Insecticide Resistance Action Committee (IRAC), a coordinated crop protection industry group, was formed to develop guidelines to delay or prevent resistance. Using their most recent IRAC MoA Brochure we have produced a table which provides Insecticide Modes of Action on Desert Produce and Melon Crops. We also provide general information on the route of activity and pest spectrum for each chemistry. These classification lists will provide you with an additional set of guidelines for the selection of insecticides that can be used in desert IPM programs.

This study was conducted at the Yuma Valley Agricultural Center. The soil was a silty clay loam (7-56-37 sand-silt-clay, pH 7.2, O.M. 0.7%). Spinach ‘Revere’ was seeded, then sprinkler-irrigated to germinate seed Jan 18, 2024 on beds with 84 in. between bed centers and containing 30 lines of seed per bed.  All irrigation water was supplied by sprinkler irrigation.  Treatments were replicated four times in a randomized complete block design.  Replicate plots consisted of 15 ft lengths of bed separated by 3 ft lengths of nontreated bed.  Treatments were applied with a CO₂backpack sprayer that delivered 50 gal/acre at 40 psi to flat-fan nozzles. 
 

Month	Max	Min	Average	Rainfall
January	68	42	54	1.14 in
February	73	47	59	0.50 in
March	77	50	63	0.31 in

 
Downy mildew (caused by Peronospora farinosa f. sp. spinaciae) was first observed in plots on Feb 19  and final reading was taken on February 26, 2024. Spray date for each treatments are listed in excel file with the results.   Disease severity was recorded by determining the percentage of infected leaves present within three 1-ft² areas within each of the four replicate plots per treatment.  The number of spinach leaves in a 1-ft² area of bed was approximately 144. 

The data (found in the accompanying Excel file) illustrate the degree of disease reduction obtained by applications of the various tested fungicides. Products that  provided effective control against the disease include Orondis ultra, Thrive 4 M, Fungout, Cevya, Eject and Zampro. No phytotoxicity was observed in any of the treatments in this trial.

Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).

In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).

Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.

If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.

References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.

Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council.  We greatly appreciate their support.

A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.

Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed!  It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials:

Results of pheromone and sticky trap catches can be viewed here.
 
Corn earworm:            
CEW moth increased the Dome Valley area last week, but areawide below average for early October.
 
Beet armyworm:         
Trap counts highest in Tacan, Wellton and Dome, but below average for early fall.
 
Cabbage looper:          
Cabbage looper numbers remained low consistent with late-September.
 
Diamondback moth:   
DBM moths beginning to appear in traps in Wellton/Dome Valley, trending on average for early fall..
 
Whitefly:                      
Adult movement down in the past week, above average for late-September. 
 
Thrips:                         
Thrips adult activity beginning to increase, and trending about average to previous years.
 
Aphids:                        
First winged adults captured for the season, consistent with heavy winds from W-NW last week. Can anticipate aphid flights to increase in the coming weeks.
 
Leafminers:                   
Adult activity tending downward in most locations, average for late-September.