Now that the spring melon harvest is well under way, it is important to begin thinking about whitefly management in fall produce and melons crops. The first line of defense in avoiding whitefly issues in the fall plantings, is for PCAs and growers do a good job of controlling whiteflies on cotton this summer. This may be particularly important since the cotton acreage has increased significantly this year. However, before whitefly management begins in cotton, it is important that whitefly populations be prevented from building up to large numbers in the spring melons that are currently being harvested. In surveying melon crops for CYSDV this spring, it became readily apparent that a large proportion of the spring melon acreage throughout the area was grown near cotton. In fact, our surveys show that on an area-wide basis more than 83% of the melon acreage this spring were grown either adjacent to, or within a 1/4 mile of, cotton (See Melon Survey). In Dome Valley and Wellton, about 95% of the melon acreage was grown adjacent to cotton. Although whitefly numbers have been relatively light thus far, increased whitefly numbers have been observed over the past week in melons coinciding with higher temperatures and area-wide melon harvests. Thus, proper sanitation in spring melons is critical to preventing unnecessary whitefly buildups in cotton. It is highly recommended that melon growers quickly destroy plant residue as soon as possible following harvest. A delay in disking under melon fields following harvest can provide a large source of adult whiteflies that will readily disperse into cotton, especially when they don't need to fly very far. These fields also potentially extend the host-acquisition period for CYSDV. Good news though, to date CYSDV incidence in spring melons has been relatively low this spring, and was most evident in the north Yuma Valley as shown in the 2011 Spring Melon CYSDV Survey.
This study was conducted at the JV farms at Gila Valley. Lettuce variety ‘Guapo’ was seeded, then sprinkler-irrigated to germinate seed on September 19, 2023, on double rows 12 in. apart on beds with 42 in. between bed centers. Rest of the irrigation was supplied by furrow irrigation or rainfall. Treatments were replicated five times in a randomized complete block design. Each replicate plot consisted of 25 ft of bed, which contained two 25 ft rows of lettuce. Plants were thinned on October 9, 2023 at the 3-4 leaf stage to a 12-inch spacing. Treatment beds were separated by single nontreated beds. Treatments were applied by incorporating in soil before seeding or with a tractor-mounted boom sprayer that delivered 50 gal/acre at 100 psi to flat-fan nozzles spaced 12 in apart.
Month
Max
Min
Avg
Rain
September
100
71
86
0.71 in
October
93
61
77
0.00 in
November
80
51
65
0.08 in
December
71
44
57
0.82 in
Fusarium wilt (caused by Fusarium oxysporum f. sp. lactucae ) rating was done in the field by observing the typical symptom of lettuce wilt. Confirmation was done by cutting the cross section of roots. Disease scoring/rating was done on December 6, 2023.
The data in the table illustrate the degree of disease control obtained by application of the various treatments in this trial. The disease pressure was extremely high in 2023, and most treatments showed little or no control against the disease. The treatments that showed some activity were Bexfond, Cevya, Rhyme, and Serifel. Plant vigor was normal and phytotoxicity symptoms were not observed in any treatments in this trial.
Controlling Fusarium Wilt of Lettuce Using Steam Heat – Trial Initiated
Earlier this week, we initiated a trial examining the use of band steam for controlling Fusarium wilt of lettuce. The premise behind this research is to use steam heat to raise soil temperatures to levels sufficient to kill soilborne pathogens. For Fusarium oxysporum f. sp. lactucae, the pathogen which causes Fusarium wilt of lettuce, the required temperature for control is generally taken to be > 140°F for 20 minutes. Soil solarization, where clear plastic is placed over the crop bed during the summer, exploits this concept. The technique raises soil surface temperatures to 150-155˚F, effectively killing the pathogen and reducing disease incidence by 45-98% (Matheron and Porchas, 2010).
In our trials, we are using steam heat to raise soil temperatures. Steam is delivered by a 35 BHP steam generator mounted on a custom designed elongated bed shaper (Fig. 1). Preliminary results were encouraging. The device was able to increase the temperature of the top 3” of soil to over 180°F at a travel speed of 0.5 mph as shown in this video of the machine in action (shown below). These temperatures exceed that of those known to control pathogens responsible for causing Fusarium wilt of lettuce (> 140°F for 20 minutes).
Stay tuned for final trial results and reports on the efficacy of using steam heat to control Fusarium wilt of lettuce.
If you are interested in evaluating the technique on your farm, please contact me. We are seeking additional sites with a known history of Fusarium wilt of lettuce disease incidence to test the efficacy and performance of the device.
References
Matheron, M. E., & Porchas, M. 2010. Evaluation of soil solarization and flooding as management tools for Fusarium wilt of lettuce. Plant Dis. 94:1323-1328.
Acknowledgements
This project is sponsored by USDA-NIFA, the Arizona Specialty Crop Block Grant Program and the Arizona Iceberg Lettuce Research Council. We greatly appreciate their support.
A special thank you is extended to Cory Mellon and Mellon Farms for allowing us to conduct this research on their farm.
Weeds are one of the most visible of all agricultural pests. They can’t move or hide and once established often stick up over the crop. Just one weed in a 10 acre field is annoying to look at. With insects and diseases, the damage is often more visible than the pest. That is not the case with weeds. A moderate weed infestation is approximately 10 weeds per square foot. If a herbicide produces 90% control, that leaves 1 weed per square foot or 43 weeds per acre. Without an untreated check, this can look like the herbicide failed! It is easy to leave an untreated spot in a field and it is well worth doing. Many applicators do so unintentionally because of skips, powerlines and other causes. They help determine crop injury and weed control. Here are some examples of what various levels of control looked like from one of our cole crop trials:
Corn earworm:
CEW moth counts remain low across all locations; average for this time of the season.
Beet armyworm:
Trap counts decreased in all locations, and below average for late-January.
Cabbage looper:
Cabbage looper trap counts remained low in all locations; below average for early February.
Diamondback moth:
Adult activity increased slightly in some locations, particularly fields where trap is adjacent to with nearby brassica seed crops. Overall, activity is below average for this time of year.
Whitefly:
Adult movement remained low in all locations consistent with previous seasons.
Thrips:
Thrips adult movement beginning to increase slightly in most locations. Activity a about average for mid-February.
Aphids:
Aphid movement increased in many locations, particularly in Yuma Valley. Trap captures about average for this time of year.
Leafminers:
Adult activity increased in most areas, below average for this time of season.
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
