May 5, 2021Summer Sanitation Is Important as Ever
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
When known weedy fields are ready to plant and labor is expected to be short, it is tempting to use all the preplant herbicides that are available. In lettuce, there are three preplant herbicides available and it is not uncommon to use 2 and occasionally all 3 on the same crop. All three of these herbicides use the same mode of action to kill weeds. There are slight differences between them but they all either stop or disrupt cell division in the roots and or stems of the weeds. They are normally safe to lettuce unless the crop is stressed or the rate, timing or placement are poor. The rationale for using multiple preplant herbicides in lettuce is often to broaden the weed control spectrum or guard against misses caused by misapplication or environmental conditions. There are some hazards, however, that sometimes outweigh the benefits. Potential crop injury is increased. All 3 use the same mode of action and the chance of injuring developing crop roots is compounded. Sometimes herbicides are added that contribute nothing but potential injury to the mix. If you look at the following chart you can see that many weeds are controlled by Kerb, for instance, that are not controlled by Balan or Prefar. Why add them? All three control grasses, goosefoot and purslane. If environmental conditions and applications are optimal it is often possible to use only one. Herbicides are much less expensive than labor, but it is possible to overdo it and cause more problems and expense.
It is that time of the year! Every year, September starts with “Is it April yet?” If you did not say that, then you cannot sit with us!
This past growing season has been an interesting one. From wearing masks at 120 degree to maintaining social distancing; while producing same amount of produce, feeding same amount of people, and dealing with same amount of disease and pests. A big thank you to everyone involved in agriculture for your hard work and perseverance.
In regards to plant health, we had plenty of disease problems to deal with this year. Below is brief report of the major diseases observed in growing season 2020/2021 and the disease we should be keeping an eye on for next growing season.
We observed a lot of fields with fusarium wilt this year. We had a lot of infected watermelon fields from Winterhaven to Yuma, Wellton, and Mohawk Valley. Rain, and overwatering of fields when plants set fruits might have contributed to the disease development.
Disease management include planting clean seeds/transplants, use of resistant cultivars, crop rotation, soil fumigation, soil solarization, grafting, biological control. An integrated approach utilizing two or more methods is required for successful disease management.
Fusarium wilt of Lettuce
Though detected in a lot of fields and some new fields, the disease pressure in lettuce was relatively low. Please continue with proper management practice for next growing season. Avoid overwatering, add soil amendments/organic matter, practice crop rotation if possible.
Lettuce dieback associated virus
Lettuce dieback is a soil-borne disease caused by two closely related viruses from the family Tombusviridae Tomato Bushy Stunt Virus (TBSV) and Lettuce Necrotic Stunt Virus (LNSV) that has been reclassified as Moroccan Pepper Virus (MPV). The disease has been observed throughout the main lettuce producing areas of California and Arizona.
Sclerotinia rot (known as lettuce drop) is caused by fungi Sclerotinia sclerotiorum and Sclerotinia minor.The initial aboveground symptom is observed as wilting of outermost layer of leaves giving an impression of stress in plants. However, as infection progresses rapidly towards other leaf layers and the entire plant wilts including the head. The entire plant/planting can collapse within the matter of 2 days when the condition is favorable. Management practices include use of subsurface drip irrigation, keeping the top 5-8cm of soil on planting bed is crucial. Deep plowing, crop rotation with non-hosts like small grains and broccoli, removal of infected plant tissue from the field etc. help reduce the inoculum level. Soil fumigation is effective though may not be economical. In Florida growers flood fallow their lettuce field for 4-6 weeks in summer which has almost 100% control of S. sclerotiorum. This is something you might wan to consider doing this summer if you have had high disease pressure in your fields this growing season.
Downy mildew has been a problem for years in lettuce as well as spinach. One of the main reason that hinders the disease management is the complexity of the pathogen. Bremia lactucae (lettuce pathogen) consists of multiple races (pathotypes), and new races continue to occur as pathogen evolves. The pathogen is one of the fastest evolving plant pathogen. And each pathotypes have developed insensitivity to fungicides to different extent. Resistant cultivar, preventative application of fungicides are effective to some extent. Reducing leaf wetness and humidity by using drip or furrow irrigation can be helpful.
Impatiens necrotic spot virus (INSV)
INSV has been detected in a number in fields mostly in Tacna/Roll/Wellton area. It has been found in lower numbers in Gila Valley. If your field has been infected with INSV this growing season, be proactive next season in regards to clearing up the weeds, managing thrip population etc. If you see symptomatic plants please let me or Dr. Palumbo know.
This week in Clinic
If you haven’t submitted your entry for Melon powdery mildew fungicide trial for this spring please send it to Dr. Bindu Poudel-Ward (email@example.com)
Mark C. Siemens
Vol. 12, Issue 9, Published 5/5/2021
Automated thinning machines have been commercially available since 2012. These machines identify crop plants and intermittently deliver an herbicidal spray or dose of liquid fertilizer to thin the stand to the desired plant spacing. Some growers have converted older machines to spot apply pesticides to crop plants rather than thin lettuce. Spot spraying just the crop plant makes sense – it reduces applied chemical amount by about 1/3rd as compared to band spraying and by roughly 90% as compared to broadcast. I have heard reports of improved efficacy with this technique, perhaps due to better coverage, however this potential benefit has not been validated in formal trials.
A drawback with automated thinning machines is their high cost. Retail prices for machines are approximately $25,000 per seed line, or about $200,000 for a 4-row, 2-line machine. Another option might be to use automated systems designed for spot spraying weeds. These devices have been commercially available since the mid 90’s and function similarly to automated thinning machines in that they use optical sensors to detect plants and solenoid activated spray assemblies to intermittingly spray unwanted plants (Fig. 1). The cost of these devices is quite reasonable – about $3,000 per unit, or about $24,000 for a 4-row, 2-line machine.
Automated spot sprayers are typically used in agriculture to control weeds in fallow fields (Fig. 2), but could easily be adapted to apply pesticides or even fertilizer to vegetable crops. Spot applying foliar fertilizers to vegetable crops is an interesting concept and is being investigated in California with lettuce.
Another potential use of spot sprayers is to control herbicide resistant weeds. The device can be positioned between crop rows to spot spray a non-selective herbicide to target weeds. Placing the sprayer in a hooded enclosure prevents unwanted drift onto crop plants. We are conducting trials using this technique in cotton this season (Fig. 3). We are also looking for collaborators interested in trying the device as a pesticide and/or fertilizer spot applicator in vegetable crops for this upcoming season. If you are interested collaborating or would like to see a demo of the device, please feel free to reach out to me.
The Yuma County Leaf Wetness Network remains in place for the 2018/19 vegetable season. Growers and PCAs may access information generated by the network by entering the following internet address: http://184.108.40.206:460
Upon entering the address above, you will be transferred to internet page that provides a series of tabs at the top of the page. Simply click on the tabs to access the information of interest.
Beet armyworm: Moth activity has declined in most trap location and remains below average for this point in the season.
Cabbage looper: Cabbage looper activity remains unusually low for early November. Trap catches picked up a bit in Wellton and Gila Valley.
Whitefly: Adult movement has been about average for this time of year. Activity highest in Wellton near fall melons being harvested.
Thrips: Thrips activity picking up significantly in several trap locations; activity increased significantly in Bard and Dome and Gila Valleys.
Aphids: Aphid numbers peaked last week in many locations, particularly in the Gilas and Yuma Valleys.
Leafminers: Adult activity increased significantly last week, particularly in the Wellton area near melons.