May 5, 2021Summer Sanitation Is Important as Ever
To contact John Palumbo go to: jpalumbo@ag.Arizona.edu
When known weedy fields are ready to plant and labor is expected to be short, it is tempting to use all the preplant herbicides that are available. In lettuce, there are three preplant herbicides available and it is not uncommon to use 2 and occasionally all 3 on the same crop. All three of these herbicides use the same mode of action to kill weeds. There are slight differences between them but they all either stop or disrupt cell division in the roots and or stems of the weeds. They are normally safe to lettuce unless the crop is stressed or the rate, timing or placement are poor. The rationale for using multiple preplant herbicides in lettuce is often to broaden the weed control spectrum or guard against misses caused by misapplication or environmental conditions. There are some hazards, however, that sometimes outweigh the benefits. Potential crop injury is increased. All 3 use the same mode of action and the chance of injuring developing crop roots is compounded. Sometimes herbicides are added that contribute nothing but potential injury to the mix. If you look at the following chart you can see that many weeds are controlled by Kerb, for instance, that are not controlled by Balan or Prefar. Why add them? All three control grasses, goosefoot and purslane. If environmental conditions and applications are optimal it is often possible to use only one. Herbicides are much less expensive than labor, but it is possible to overdo it and cause more problems and expense.
Damping off is a common problem in spinach. This season we have observed the occurrence of the disease from Imperial valley, to Yuma and all the way to Wellton.
Symptoms of damping‑off and root rot consist of poor seed germination, preemergence death of seedlings, postemergence death of newly emerged seedlings, stunted plants, yellowed lower leaves, general poor growth, wilting, and eventual collapse and death of older plants. The upper taproot may be girdled by a necrotic lesion, or the tip of the taproot may be necrotic. In severe cases, nearly all roots may be girdled or rotted off. Damping-off is problematic in spinach production areas throughout the world. Severity is influenced by cultivar, soil texture, irrigation, and pathogen populations. Severe damping-off is associated with clay or poorly draining soils with a history of frequent spinach production. While all stages of spinach can be infected by root rot organisms, newly emerging plants and young seedlings are very susceptible.
Symptoms are more prominent in areas with poor drainage. These spinach problems are caused by a complex of pathogenic soil fungi that include one or more of the following: Fusarium oxysporum, Pythium (several species), and Rhizoctonia solani. These fungi are present in most soils and can get aggressive and cause loss when the environment is favorable. However, aboveground symptoms of plants that are overwatered are similar to symptoms of root rot. Excess water can damage roots, causing tan to brown, water‑soaked symptoms on roots even if no pathogen is present.
Plant spinach in well draining soils. Prepare seed beds so that even, rapid germination is enhanced. Carefully manage the irrigation schedule to prevent flooding and saturated soil conditions. Plant seed that is treated with fungicides and fumigate the beds. Preplant application of mefenoxam will only control damping-off caused by Pythium. Avoid planting consecutive spinach crops and practice good crop rotation.
Always remember the disease triangle, the necessity of a susceptible host, the favorable environment, and virulent pathogen. To create unfavorable environment avoid overwatering, do light but frequent irrigation to avoid standing water in the field, schedule watering in the morning or earlier part of the day. Addition of soil amendments to increase microbial activity can be helpful.
Mark C. Siemens
Vol. 12, Issue 9, Published 5/5/2021
Automated thinning machines have been commercially available since 2012. These machines identify crop plants and intermittently deliver an herbicidal spray or dose of liquid fertilizer to thin the stand to the desired plant spacing. Some growers have converted older machines to spot apply pesticides to crop plants rather than thin lettuce. Spot spraying just the crop plant makes sense – it reduces applied chemical amount by about 1/3rd as compared to band spraying and by roughly 90% as compared to broadcast. I have heard reports of improved efficacy with this technique, perhaps due to better coverage, however this potential benefit has not been validated in formal trials.
A drawback with automated thinning machines is their high cost. Retail prices for machines are approximately $25,000 per seed line, or about $200,000 for a 4-row, 2-line machine. Another option might be to use automated systems designed for spot spraying weeds. These devices have been commercially available since the mid 90’s and function similarly to automated thinning machines in that they use optical sensors to detect plants and solenoid activated spray assemblies to intermittingly spray unwanted plants (Fig. 1). The cost of these devices is quite reasonable – about $3,000 per unit, or about $24,000 for a 4-row, 2-line machine.
Automated spot sprayers are typically used in agriculture to control weeds in fallow fields (Fig. 2), but could easily be adapted to apply pesticides or even fertilizer to vegetable crops. Spot applying foliar fertilizers to vegetable crops is an interesting concept and is being investigated in California with lettuce.
Another potential use of spot sprayers is to control herbicide resistant weeds. The device can be positioned between crop rows to spot spray a non-selective herbicide to target weeds. Placing the sprayer in a hooded enclosure prevents unwanted drift onto crop plants. We are conducting trials using this technique in cotton this season (Fig. 3). We are also looking for collaborators interested in trying the device as a pesticide and/or fertilizer spot applicator in vegetable crops for this upcoming season. If you are interested collaborating or would like to see a demo of the device, please feel free to reach out to me.
Results of pheromone and sticky trap catches can be viewed here.
We have started our Areawide Insect and DBM Trapping Network for the 2019-20 season.
We have added another trapping location in Bard, CA.
Area wide Insect Trapping Network VegIPM Update, Vol. 11, No. 20, Sep 30, 2020
Results of pheromone and sticky trap catches can be viewed here.
Corn earworm: Moth activity about normal for September but beginning to increase, particularly in Dome Valley and south Yuma Valley.
Beet armyworm: Moths remain active throughout the desert, especially in Texas Hill and Tacna growing areas- Staring to pick up in the south Yuma Valley.
Cabbage looper: Cabbage looper activity unusually low for mid-late September. Larvae just starting to show up in some fields.
Whitefly: Adult movement has been relatively light and about average for this time of year. Activity highest in Dome Valley.
Thrips: To date, thrips activity has been seasonably low at all trap locations; most activity found in Bard. Numbers beginning to slowly trend upward
Aphids: No aphids have been caught on traps thus far. Normal for this time of year. Still early, anticipate they will begin to show up in October.
Leafminers: Adult activity below normal for September, but moderate numbers caught in Wellton and south Gila Valley in areas where cotton was recently harvested and disked under.