Estimation of evapotranspiration for specific crops (ETc) is important for irrigation scheduling and agricultural water management. ETc for crops such can be estimated using the following equation:

ETc = ETo x Kc

Where ETo is the evapotranspiration (ET) of a reference crop (usually grass or alfalfa), which is commonly called reference ET Reference ET (ETo) is defined as the ET from a 3-6" tall cool season grass that completely covers the ground and is supplied with adequate water. ETo is commonly used mostly in the eastern, southern, southeastern, and western U.S.

Reference ET (ETr) assumes a reference surface of tall grass (or alfalfa-20" tall) that completely covers the ground and is supplied with adequate water. ETr is more commonly used in the Midwest.

Both ETc and ETo can be expressed in units of water depth per unit of time, such as inches per day, inches per week, or inches per month. ETo is usually estimated using equations that use weather variables as inputs. These variables include solar radiation, air temperature, wind speed, and relative humidity. Reference ET or ETo can be obtained from AZMET Weather Data (https://cales.arizona.edu/AZMET/az-data.htm) 

Figure 1: The Arizona Meteorological Network

The Kc is an adjustment factor called the “crop coefficient,” which mainly depends on the type of crop and its growth stage. Usually determined experimentally. Each agronomic crop has specific crop coefficients to predict water use rates at different growth stages and could be obtained from university extension or agricultural research center.

Example 1:
A lettuce crop is at the KcD growth stage, with a crop coefficient (Kc) of 0.80 (as indicated in the Kc table). The reference evapotranspiration (ETo) from October 20 to 24 is 1.20 inches over a 7-day period since the last irrigation, based on AZMET data. Determine the actual crop evapotranspiration (ETc), which also represents the total irrigation requirement, assuming the irrigation system operates at 100% efficiency.

Solution:

ETc=ETo *Kc
Kc @ KcD is 0.80
ETo = 1.20 inches
ETc: 1.20 inches * 0.80
= 0.96 inches is actual crop water use which is total irrigation requirement that needs to apply.